Search GDR Data

Showing results 251 - 275 of 280.
Show results per page.
Order by:
Available Now:
Clear All Filters ×
Technologies
Featured Projects
Topics
Data Type
"well stimulation seismic data"×
Utah FORGE×

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Curated

Utah FORGE: Slide-Hold-Slide Experiments on Westerly Granite at Temperatures up to 250 Degrees C

Laboratory slide-hold-slide tests were conducted in a conventional triaxial deformation configuration on 1-inch diameter cylindrical cores of Westerly granite bisected by a sawcut oriented at 30 degrees from vertical. Tests were conducted at a constant confining pressure of 30 MPa...
Jeppson, T. et al United States Geological Survey
Oct 10, 2023
2 Resources
0 Stars
Curated

Utah FORGE: 2020-2021 Geothermal Energy/EGS Survey and Results

The Utah FORGE project collaborated with the University of Utahs Department of Communication on a Capstone course during Fall Semester 2020. The course created a survey to gauge the general populations knowledge of geothermal energy and Enhanced Geothermal Systems (EGS). The surve...
Yeo, S. and McKasy, M. Energy and Geoscience Institute at the University of Utah
Jul 20, 2021
1 Resources
0 Stars
Curated

Utah FORGE: Area 0.5 m LiDAR Data

During the Fall of 2016 AGRC and the Utah Geological Survey acquired ~205 square miles of 8 points per meter Quality Level 1 LiDAR of The Frontier Observatory for Research in Geothermal Energy (FORGE) area around Milford, Utah in Beaver and Millard Counties in western Utah. The 0....
Allis, R. Energy and Geoscience Institute at the University of Utah
Oct 01, 2016
1 Resources
0 Stars
Publicly accessible

Utah FORGE: InSAR Data from 2021

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Nov 30, 2021
9 Resources
0 Stars
Curated

Utah FORGE: InSAR Data from 2020

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Dec 24, 2020
9 Resources
0 Stars
Curated

Utah FORGE: InSAR Data from 2022

Interferometric Synthetic Aperture Radar data from the TerraSAR-X and the TanDEM-X satellite missions operated by the German Space Agency (DLR). Interferometric pairs (interferograms) were created using generic mapping tool GMT-SAR processing software (see link in Resources). Data...
Batzli, S. and Feigl, K. University of Wisconsin
Nov 30, 2022
9 Resources
0 Stars
Curated

Utah FORGE: Geochemical Data for Cold Groundwaters and Produced Geothermal Fluids

Geochemical data for cold groundwaters and produced geothermal fluids around the Utah FORGE site. The data is compiled into four tables in the attached Excel File. Table 1 is a compilation of compositions (anions, cations, weak acids, oxygen, hydrogen, and carbon isotopes) for c...
Simmons, S. and Kirby, S. Energy and Geoscience Institute at the University of Utah
Aug 16, 2024
2 Resources
0 Stars
Curated

Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...
Jeppson, T. and Lockner, D. United States Geological Survey
Feb 24, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Temperature Gradient Database

This is a temperature gradient database for Utah, USA. It is located at the Utah Geological Survey. This contains data relevant to the Utah FORGE project.
Nash, G. Energy and Geoscience Institute at the University of Utah
Feb 01, 2004
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Interferometric Synthetic Aperture Radar Data from 2023 and 2024

The dataset comprises Interferometric Synthetic Aperture Radar (InSAR) data from the TerraSAR-X and TanDEM-X satellite missions, covering the Utah FORGE site. This data includes interferometric pairs created using GMT-SAR processing software, chosen for their short orbital separat...
Batzli, S. and Feigl, K. University of Wisconsin Madison
Jul 17, 2024
10 Resources
0 Stars
Curated

Utah FORGE: Phase Native State FALCON Model Files

The submission includes FALCON input file and mesh for the an initial pressure-temperature simulation, and a second set for pressure-temperature-displacement simulation. All simulations are steady state. Data and input for the FORGE Phase 2 native state model were compiled from hi...
Podgorney, R. Idaho National Laboratory
Jun 06, 2019
2 Resources
0 Stars
Curated

Utah FORGE: Soil Carbon Dioxide Data

These are data from soil CO2 flux surveys done in the Utah FORGE study area near Roosevelt Hot Springs. Concentration is in units of ppm and is the final concentration of CO2 in the chamber after the up-to-2-minute flux measurement. Flux is in units of grams of CO2 per m^2.
Rahilly, K. Energy and Geoscience Institute at the University of Utah
Mar 12, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Earth Model Native State Simulation Results

Utah FORGE phase 2C Native State Simulation zip contains the data used for the boundary conditions and subsequent native state simulation results obtained using the simulation code FALCON. Data are from the nodes of the simulation domain, with used a uniform 50m spacing over a 250...
Podgorney, R. Energy and Geoscience Institute at the University of Utah
Jul 16, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE: InSAR Data Best Pairs

This submission provides Interferometric Synthetic Aperture Radar (InSAR) data covering the Utah FORGE site via the TerraSAR-X and TanDEM-X satellite missions operated by the German Space Agency (DLR). Data was collected between 2019/01/01 and 2023/06/30. Interferometric pairs (...
Batzli, S. and Feigl, K. University of Wisconsin Madison
May 31, 2023
11 Resources
0 Stars
Curated

Utah FORGE: Soil Helium R/RA Data

This is a Helium isotope R/RA values from the Utah FORGE area near Roosevelt Hot Springs.
Simmons, S. Energy and Geoscience Institute at the University of Utah
Mar 12, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 InSAR Study Results

Ground movement is evaluated through analysis of Interferometric Synthetic Aperture Radar (InSAR) interferograms. Results indicate there has been no detectable ground movement at millimeter scale. The zipped file in this submission contains a report, maps, and results from the InS...
Feigl, K. and Batzli, S. Department of Geoscience University of Wisconsin-Madison
Sep 24, 2020
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Geology Map and GIS Data

This archive contains a geology map of the general Roosevelt Hot Springs region, both in PDF and ArcGIS geodatabase formats, that was created as part of the Utah FORGE project.
Kirby, S. et al Energy and Geoscience Institute at the University of Utah
Mar 15, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Temperature Contours

This submission contains several ArcGIS shapefiles, each with Temperature contour lines at different depths. Subsurface temperature were important for characterizing the geothermal system beneath the FORGE site in Milford, Utah.
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 09, 2016
5 Resources
0 Stars
Publicly accessible

Utah FORGE: Area LiDAR Bare Earth DEM Mosaic

This is a mosaic of 154 bare earth DEM panels (0.5 m resolution) acquired during Phase II of the Utah FORGE project. The DEM covers the western Mineral Mountains and adjoining basin including the Roosevelt Hot Springs area. The coordinates are in UTM Zone 12, NAD 83 and elevation ...
Nash, G. Energy and Geoscience Institute at the University of Utah
Aug 07, 2018
1 Resources
0 Stars
Publicly accessible

Purdue University: Results of B-Value Tests for Rock Saturation

This dataset includes an Excel file with the results of B-value tests to determine the magnitude of the back pressure required for full saturation of Sierra White granite samples. Test were conducted on cylindrical rock specimens of Sierra White granite in a custom water pressuriz...
Han, K. et al Purdue University
Jun 20, 2022
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...
Lockner, D. et al United States Geological Survey
Apr 03, 2023
2 Resources
0 Stars
Curated

Utah FORGE 2-2439: A Multi-Component Approach to Characterizing In-Situ Stress: Laboratory, Modeling and Field Measurement Workshop Presentation

This is a presentation on A Multi-Component Approach to Characterizing In-Situ Stress at the U.S DOE FORGE EGS Site: Laboratory, Modeling and Field Measurement project by Battelle [Columbus, OH], presented by Mark Kelley. The project's objective was to characterize stress in the U...
Kelley, M. and Bunger, A. Battelle Memorial Institute
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Geologic Maps

This is a link to Utah geology maps in both pdf and GIS formats. This includes the geology of the Utah FORGE area. This site is maintained by the Utah Geological Survey.
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 02, 2016
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Targeting Geothermal Resources with Geodetic Strain Data Paper

The paper linked below offers an initial assessment of a new method to target potential geothermal resources on the regional scale. The method is based on seeking relationships between geologic structures and geodetic observations of regional tectonic strain.
Blewitt, G. et al Energy and Geoscience Institute at the University of Utah
Oct 01, 2004
1 Resources
0 Stars
Curated
<< Previous6789101112Next >>