Search GDR Data
Showing results 1 - 25 of 109.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
The files in this submission describes the results of a series of stress measurement and hydraulic fracturing experiments conducted at the Sanford Underground Research Facility (SURF) in Lead, SD. This report describes the accomplishments of the kISMET (permeability (k) and Induce...
The EGS Collab experiment 2 was focused on testing shear stimulation techniques. Shear stimulation, in this case, means using hydraulic pressure to cause shear slip on preexisting fracture or fault planes such that the hydraulic conductivity of the fracture or fault increases. The...
Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...
The primary objective of our current research is to develop a computational test bed for evaluating borehole techniques to enhance fluid flow and heat transfer in enhanced geothermal systems (EGS). Simulating processes resulting in hydraulic fracturing and/or the remobilization of...
This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...
This repository contains the electrical resistivity tomography (ERT) monitoring data that was collected before, during, and after shear stimulation attempts were conducted at EGS Collab. These tests were carried out on the SURF 4100 level during Experiment 2 in March, 2022. Flow a...
The report reviews results obtained by Neubrex using Distributed Acoustic Sensing (DAS) during the 16B(78)-32 hydraulic fracturing operations, Stages 1–4. It details DAS data acquisition, processing, and analysis, with a focus on acoustic noise signatures recorded during each st...
Hydraulic shearing is an appealing reservoir stimulation strategy for Enhanced Geothermal Systems. It is believed that hydro-shearing is likely to simulate a fracture network that covers a relatively large volume of the reservoir whereas hydro-fracturing tends to create a small nu...
This report documents the use of fiber optic Rayleigh frequency shift (RFS) Distributed Strain Sensing (DSS), Distributed Temperature Sensing (DTS), and microseismic data recorded during the hydraulic fracture stimulation of well 16A(78)-32, as detected in the offset well 16B(78)-...
This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...
This dataset contains the final technical report and closeout presentation for the project A Strain Sensing Array to Characterize Deformation at the Utah FORGE Site, carried out from 2021 to 2025 by Clemson University in collaboration with the U.S. Geological Survey and UNAVCO. Th...
This is a pair of PowerPoint presentations from Neubrex Energy Services (US), LLC. The presentations review work done in April 2024 on crosswell strain fracture driven interactions (FDI) and microseismic event monitoring during hydraulic fracturing in stage 8 of Utah FORGE well 16...
This dataset includes data from injection/fall-off experiments conducted in controlled laboratory settings. The aim is to investigate the physics governing fracture closure and the associated stress measurements during hydraulic fracturing. These time series data include flow rat...
This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...
This report examines the fiber optic measurements made on the Utah FORGE well 16B(78)-32 after it and well 16A(78)-32 were hydraulically stimulated and shortly thereafter a 9 hour cross well circulation test was run between them. The report reviews distributed fiber optic signal p...
A corrigendum was submitted to the journal of Geothermics on our article "Environmentally friendly, rheoreversible, hydraulic-fracturing fluids for enhanced geothermal systems" Shao et al Geothermics 58 (2015) 22-31.
In the original article some permeability values were underesti...
This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...
Low permeability geothermal reservoirs can be stimulated by hydraulic fracturing to create Enhanced (or Engineered) Geothermal Systems (EGS) with higher permeability and improved heat transfer to increase heat production. In this paper, we document our effort to develop a numerica...
Numerical modeling on fused silica cylindrical materials for predicting overpressures required to fracture an homogeneous pure (surrogate) material with known mechanical properties similar to igneous rock materials and later compare these values to experimental overpressures obtai...
This report discusses the results of research on the ability to create and/or reactivate and subsequently sustain fracture systems which are strongly influenced by complexly coupled mechanical (M) and chemical (C) processes in reservoirs forced from equilibrium by hydraulic stimul...
This report documents the post-hydraulic fracturing extended circulation test between Utah FORGE wells 16A and 16B conducted in August 2024. In well 16B, fiber optic measurements of Rayleigh frequency shift distributed strain sensing (RFS-DSS) and distributed temperature sensing ...
Hydraulic fracturing is currently the primary method for stimulating low-permeability geothermal reservoirs and creating Enhanced (or Engineered) Geothermal Systems (EGS) with improved permeability and heat production efficiency. Complex natural fracture systems usually exist in ...
This dataset contains seismic event catalogs from the hydraulic stimulation of wells 16A(78)-32 and 16B(78)-32 at the Utah FORGE site in April 2024. The data was collected by Geo Energy Suisse (GES) using a variety of seismic monitoring technologies, including 3-component (3C) geo...
The EGS Collab project is evaluating a site for Experiment 2 (hydraulic fracturing/shearing) at a depth of 1.25 km in the Sanford Underground Research Facility (SURF) on the 4100 Level. Two early test holes were drilled in an alcove (formerly known as Battery Charging Station) nea...
This dataset documents frac hit observations recorded in well 16B(78)-32 during hydraulic stimulation of well 16A(78)-32 in April 2024 at the Utah FORGE site. The spreadsheet provides a chronological record of identified frac hits, including an event label, measured depth in feet ...
Google Map