Search GDR Data

StimuFrac Compressibility as a Function of CO2 Molar Fraction

Compressibility values were obtained in a range of pressures at 250degC by employing a fixed volume view cell completely filled with PAA aqueous solution and injecting CO2 at constant flow rate (0.3mL/min). Pressure increase as a function of supercritical CO2 (scCO2) mass fraction...

A., C. Pacific Northwest National Laboratory

Apr 29, 2016
1 Resources
0 Stars
Publicly accessible

Hawaii Play Fairway Analysis: Oahu Groundwater Flow Model

Groundwater flow model for the island of Oahu. Data is from the following sources: Rotzoll, K., A.I. El-Kadi. 2007. Numerical Ground-Water Flow Simulation for Red Hill Fuel Storage Facilities, NAVFAC Pacific, Oahu, Hawaii Prepared TEC, Inc. Water Resources Research Center, Univer...

Lautze, N. University of Hawaii

Jan 01, 2015
1 Resources
0 Stars
Publicly accessible

Modeling Responses of Naturally Fractured Geothermal Reservoir to Low-Pressure Stimulation

Hydraulic shearing is an appealing reservoir stimulation strategy for Enhanced Geothermal Systems. It is believed that hydro-shearing is likely to simulate a fracture network that covers a relatively large volume of the reservoir whereas hydro-fracturing tends to create a small nu...

Fu, P. and Carrigan, C. Lawrence Livermore National Laboratory

Jan 01, 2012
2 Resources
0 Stars
Publicly accessible

Dataset and SUTRA model used to evaluate Reservoirs for Thermal Energy Storage in the Portland Basin, Oregon.

This is a link to the open access, published dataset and modeling that supports a feasibility study of Reservoir Thermal Energy Storage (RTES) in the Portland Basin, Oregon, USA. Citation: Burns, E.R., 2020, SUTRA model used to evaluate Saline or Brackish Aquifers as Reservoirs f...

Bershaw, J. et al Portland State University

Jun 29, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Native State Model 2022 Update

This is the Phase 3 native state model update. The Phase 3 numerical model represents a significant subsurface volume below the FORGE site footprint. The model domain of 4.0 km x 4.0 km x 4.2 km is located approximately between depths of 4000 to 4200 meters below land surface. Thi...

Podgorney, R. and Liu, R. Idaho National Laboratory

Jul 29, 2022
1 Resources
0 Stars
Publicly accessible

3D Model of the San Emidio Geothermal Area

The San Emidio geothermal system is characterized by a left-step in a west-dipping normal fault system that bounds the western side of the Lake Range. The 3D geologic model consists of 5 geologic units and 55 faults. Overlying Jurrassic-Triassic metasedimentary basement is a ~500 ...

E., J. University of Nevada

Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Altona Field Lab Inverse Model WRR 2020

Includes data for measured inert tracer breakthrough curves first reported in Hawkins (2020) (Water Resources Research). In addition, this submission includes the production well temperature measurements first reported in Hawkins et al. (2017a) (Water Resources Research, volume 53...

Tester, J. Cornell University

Jan 01, 2015
3 Resources
0 Stars
Publicly accessible

Simulating Complex Fracture Systems in Geothermal Reservoirs Using an Explicitly Coupled Hydro-Geomechanical Model

Low permeability geothermal reservoirs can be stimulated by hydraulic fracturing to create Enhanced (or Engineered) Geothermal Systems (EGS) with higher permeability and improved heat transfer to increase heat production. In this paper, we document our effort to develop a numerica...

Carrigan, C. et al Lawrence Livermore National Laboratory

Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Life Cycle Water Consumption and Water Resource Assessment for Utility-Scale Geothermal Systems: An In-Depth Analysis of Historical and Forthcoming EGS Projects

This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...

Schroeder, J. et al Argonne National Laboratory

Aug 31, 2013
11 Resources
1 Stars
Publicly accessible

GEO3D Three-Dimensional Computer Model of a Ground Source Heat Pump System

This file is the setup file for GEO3D, a computer program written by Jim Menart to simulate vertical wells in conjunction with a heat pump for ground source heat pump (GSHP) systems. This is a very detailed three-dimensional computer model. This program produces detailed heat tran...

Menart, J. Wright State University

Jun 07, 2013
3 Resources
0 Stars
Publicly accessible

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...

Polsky, Y. et al Oak Ridge National Laboratory

Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Fine Scale Stress Test Modelling

Mesh, properties, initial conditions, injection/withdrawal rates for modelling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, fo...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 22, 2021
14 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase 3 Magnetotelluric (MT) Data

New high-quality tensor MT data at 122 sites, including the vertical magnetic field and utilizing ultra-remote referencing, have been acquired over the Utah FORGE project area. The results will be used to delineate the densities of faults and fractures in crystalline basement rock...

Wannamaker, P. and Maris, V. Energy and Geoscience Institute at the University of Utah

Oct 01, 2020
5 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2417: Pulsed Interference Tests at Wells 16A(78)-32 and 16B(78)-32 September 2024

This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...

W Becker, M. et al Rice University

Mar 18, 2025
3 Resources
0 Stars
Publicly accessible

University of Illinois Campus Deep Direct-Use Feasibility Study Regional Geology

Links to papers and reports describing the structure and character of the Illinois Basin geology. Included are descriptions of the two reservoirs that are being modeled for the DDU feasibility project at University of Illinois, the St. Peter and Mt. Simon Sandstones.

Lin, Y. et al University of Illinois

Mar 30, 2018
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Schlumberger FMI Logs DLIS and XML files

This zipped data set includes Schlumberger FMI logs DLIS and XML files from Utah FORGE deep well 58-32. These include runs 1 (2226-7550 ft) and 2 (7440-7550 ft). Run 3 (7390-7527ft) was acquired during phase 2C.

Nash, G. and Moore, J. Energy and Geoscience Institute at the University of Utah

Nov 17, 2017
4 Resources
0 Stars
Publicly accessible

Low-Temperature Hydrothermal Resource Potential Estimate

Compilation of data (spreadsheet and shapefiles) for several low-temperature resource types, including isolated springs and wells, delineated area convection systems, sedimentary basins and coastal plains sedimentary systems. For each system, we include estimates of the accessible...

Mullane, M. et al National Renewable Energy Laboratory

Jun 30, 2016
3 Resources
1 Stars
Publicly accessible

Thermal-Hydrological-Mechanical Modelling of Stockton University Reservoir Cooling System, Large Scale Grid

Mesh, properties, initial conditions, injection/withdrawal rates for modeling thermal, hydrological, and mechanical effects of fluid injection to and withdrawal from ground for Stockton University reservoir cooling system (aquifer storage cooling system), Galloway, New Jersey, on ...

Smith, J. et al Lawrence Berkeley National Laboratory

Feb 26, 2021
15 Resources
0 Stars
Publicly accessible

Seismic Survey 2016 Data at Crescent Valley, Nevada

In September 2016, 989 vertical-component seismic instruments were deployed for 75 hours at the Crescent Valley greenfield geothermal play area in Nevada. Data were recorded 12/9/16 12/15/16. Data are stored in individual files in one-minute increments in SEGD formats. See the met...

Lord, N. et al University of Wisconsin Madison

Dec 04, 2023
6 Resources
0 Stars
Publicly accessible

Hawthorne Nevada Deep Direct-Use Feasibility Study 3D Seismic

The objective of this project is to use a multi-disciplinary, three-tiered approach to assess the geothermal resource and determine the feasibility of implementing a large-scale, direct-use facility for the Hawthorne Army Depot (HAD) and the various town and county facilities in H...

Lowry, T. et al Nevada Bureau of Mines and Geology

Mar 29, 2018
6 Resources
0 Stars
Publicly accessible

Seismic Analysis of Spatio-Temporal Fracture Generation During EGS Resource Development Full Moment Tensors and Stress Inversion Catalogs

This submission contains 167 full moment tensor (MT) solutions for the seismicity observed two years prior and three years post start of injection activities. Also included are the azimuth and plunge angles for the three main stress directions sigma1, sigma 2 and sigma 3 at the P...

Gritto, R. et al Array Information Technology

Sep 26, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Optimization of a Plug-and-Perf Stimulation (Fervo Energy)

Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy. Objective and Purpose: Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...

Norbeck, J. et al Fervo Energy

Feb 08, 2023
3 Resources
1 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...

Ingraham, M. et al Sandia National Laboratories

Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Distributed Fiber Optic Temperature Data (DTS)

Distributed fiber optic sensing was an important part of the monitoring system for EGS Collab Experiment #2. A single loop of custom fiber package was grouted into the four monitoring boreholes that bracketed the experiment volume. This fiber package contained two multi-mode fiber...

Rodriguez Tribaldos, V. et al Lawrence Berkeley National Laboratory

Nov 08, 2022
10 Resources
0 Stars
Publicly accessible

High-Pressure and High-Temperature (HPHT) Lost Circulation Material (LCM) Testing

High-pressure and high-temperature (HPHT) lost circulation material (LCM) rheology test results, LCM particle size distributions (PSD) analysis, and HPHT LCM fluid loss test results. Three academic papers / reports derived from this research are also presented.

Salehi, S. and Vivas, C. University of Oklahoma

Nov 30, 2021
6 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 Next >>