Search GDR Data
Showing results 1 - 25 of 380.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
Grid-scale energy storage has been identified as a needed technology to support the continued build-out of intermittent renewable energy resources. As of April 2017, the U.S. had approximately 24.2 GW of energy storage on line, compared to 1,081 GW of installed generation capacity...
This dataset accompanies the paper "Geothermal district energy systems coupled with seasonal underground thermal energy storage: a U.S. techno-economic screening by climate and geology." It contains the data and scripts required to reproduce the study's results across ten U.S. cit...
This dataset contains 1-second and hourly resolution water flow rate, pressure, temperature, and electrical conductivity data collected during Test 1 of the DEMO Fracture Thermal Energy Storage (FTES) project at the Sanford Underground Research Facility (SURF) between December 10,...
Geothermal growth is limited by a lack of geographically dispersed high-temperature thermal resources and high initial upfront investment in characterization and well construction. This project intended to address the challenges of energy supply intermittency and enhance grid resi...
Submitted data include simulations related to underground thermal battery (UTB) simulations described in Modeling and efficiency study of large scale underground thermal battery deployment, presented at GRC, October 2021.
The UTB is comprised of a tank of water, a helical heat ex...
Groundwater Chemistry data for the Portland Basin was compiled from published literature, as well as state and federal groundwater quality reports. Mineralogies were identified based on previous literature, as well as XRD and SEM analysis conducted at Portland State University. Up...
Included in this dataset is a spreadsheet with the primary fault information used in the basin model, a spreadsheet with earthquake magnitude estimates, and a figure showing location of faults and microseismicity in the Portland Basin
The Portland Basin is a prime location to assess the feasibility of DDU-TES because natural geologic conditions provide thermal and hydraulic separation from overlying aquifers that would otherwise sweep away stored heat. Under the Portland Basin, the lower Columbia River Basalt G...
Porosity and permeability data from published and unpublished sources for the St. Peter and Mt. Simon Sandstones in the Illinois Basin.
This dataset provides the numerical source data underlying selected figures in an associated study of cooling system performance for college buildings at the University of Puerto Rico at Rio Piedras. The data include modeled cooling demand, ground heat exchanger temperatures and t...
Hydraulic responses from periodic hydraulic tests conducted at the Mirror Lake Fractured Rock Research Site, during the summer of 2015. These hydraulic responses were measured also using distributed acoustic sensing (DAS) which is cataloged in a different submission under this gr...
Archive contains thermal-mechanical simulation input/output files. Included are files which fall into the following categories:
( 1 ) Spreadsheets with various input parameter calculations
( 2 ) Final Simulation Inputs
( 3 ) Native-State Thermal-Hydrological Model Input File Fol...
This dataset encompasses the development of a geothermal energy system for the West Woodlawn neighborhood in Chicago, Illinois. This project is part of a broader initiative to design and deploy geothermal heating and cooling systems at a community scale. The dataset includes therm...
The Closed-Loop Geothermal Working Group and the National Renewable Energy Laboratory (NREL) have studied the performance of disc-shaped and linear thermal enhancements (conductive material introduced around a wellbore) in closed-loop geothermal systems. COMSOL models were develop...
This dataset contains chemical analyses for thermal wells and springs in Southeastern Idaho. Data includes all major cations, major anions, pH, collection temperature, and some trace metals. These samples were collected in 2014 by the Center for Advanced Energy Studies (CAES), an...
Groundwater flow model for the island of Oahu. Data is from the following sources:
Rotzoll, K., A.I. El-Kadi. 2007. Numerical Ground-Water Flow Simulation for Red Hill Fuel Storage Facilities, NAVFAC Pacific, Oahu, Hawaii Prepared TEC, Inc. Water Resources Research Center, Univer...
This dataset includes a consistent framework of annual, quarterly, and hourly energy demand and operational profiles for 63 U.S. manufacturing subsectors defined by NAICS classification, building on the county-level demand dataset "Updated U.S. Low-Temperature Heating and Cooling ...
Photos of core samples from Lanai Island. During the third phase of the Hawaii Play Fairway project, further exploration involved drilling a groundwater well in Lanai's Palawai Basin and performing more geophysical surveys. The project deepened an existing water well on Lanai. Dri...
This data set was used to calculate the technical potential and economic feasibility of transported geothermal energy, according to the methodology outlined in the final report included below.
Provided here are a final thermal conductivity test report, a drilling log, and a heat rejection log from Carbondale, CO. Also attached is a report made before drilling, which contains predictions on the hydrogeologic conditions of the drill site. The forty-eight (48.9) hour in-si...
The principal task of GEOTHERM is to provide information and research support for the conduct of national geothermal-resource assessments. The principal users of GEOTHERM are those involved with the Geothermal Research Program of the U.S. Geological Survey. These data include a pa...
This data includes results on an analysis of existing and projected energy, cost, and carbon for the City of Ann Arbor District Geothermal Design and Deployment to Equitably Decarbonize Low Income Neighborhoods in Ann Arbor project. The scope of the project includes designing and ...
Thermal conductivity (TC) data taken for different wells at a specified drill depth. This is an abridged version of the complete SMU heat flow database, downloaded from the SMU node of the NGDS at the beginning of INGENIOUS (approximately April 2021), and filtered to the INGENIOUS...
Provided here are various forms of the Stanford Thermal Earth Model, as well as the data and methods used for its creation. The predictions produced by this model were visualized in two-dimensional spatial maps across the modeled depths (0-7 km) for the conterminous United States....
Critical and trace element data for drill cuttings from Beowawe, Dixie Valley, and Roosevelt Hot Springs-Blundell geothermal production fields, for drill cuttings from Uinta basin producing oil-gas wells, and from outcrops in the Sevier Thermal Anomaly-Utah.
Google Map