Search GDR Data
Showing results 1176 - 1200 of 1286.
Show
results per page.
Order by:
Available Now:
Technologies
Featured Projects
Topics
Data Type
Chlorite Dissolution Kinetics at Variable pH and Temperatures up to 275C
FY13 annual report describing the calculations and results associated with the data and dissolution rate contained in "Chlorite Kinetic Dissolution Data and Rate" (linked below).
Carroll, S. and Smith, M. Lawrence Livermore National Laboratory
Oct 01, 2013
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Orientation of Borehole and Surface Seismic Stations
The University of Utah Seismograph Stations (UUSS) are responsible for the seismic monitoring of the experiments and have installed a series of permanent surface and borehole seismic instruments around the Utah FORGE project site. This report discusses the methods used for proper ...
Bradshaw, P. et al University of Utah Seismograph Stations
Jun 21, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Test Report for Detonation Velocity Measurements
Test report for detonation velocity measurements. A series of tests were conducted to determine reaction rate and general behavior of aluminum (AL) and magnesium (MG) powder mixtures (metalized explosives) with Bullseye double-base smokeless propellant. Given the indeterminate sen...
Grubelich, M. Sandia National Laboratories
Jan 13, 2014
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Brady 1D Seismic Velocity Model Ambient Noise Prelim
Preliminary 1D seismic velocity model derived from ambient noise correlation. 28 Green's functions filtered between 4-10 Hz for Vp, Vs, and Qs were calculated. 1D model estimated for each path. The final model is a median of the individual models. Resolution is best for the top 1 ...
J., R. Lawrence Livermore National Laboratory
Oct 25, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Soil Carbon Dioxide Data
These are data from soil CO2 flux surveys done in the Utah FORGE study area near Roosevelt Hot Springs. Concentration is in units of ppm and is the final concentration of CO2 in the chamber after the up-to-2-minute flux measurement. Flux is in units of grams of CO2 per m^2.
Rahilly, K. Energy and Geoscience Institute at the University of Utah
Mar 12, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
REE Sorption Study of Seived 50 +100 Mesh Fraction of Media 1 in Brine 1 at Different Concentrations of REE at 70C
This dataset shows the sorption capacities of smaller grain size (-50 +100 mesh) of media #1 in brine #1 at different starting concentrations of REE's at elevated temperature of 70C. The experimental conditions are 2g of 50 +100 mesh media #1 to 150mL of REE solution at concentrat...
Garland, G. Tusaar Corp.
Jun 29, 2015
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
S-Layer Nanosheet Binding of Zn and Gd
This data characterizes binding of Zn2+ and Gd3+ to engineered nanosheets at 40C and in a brine solution. The engineered nanosheets are composed of surface-layer (S-layer) proteins which form 2 D crystalline sheets and display Zn2+ or Gd3+-binding domains on these sheets. Their ab...
Ajo-Franklin, C. et al Lawrence Berkeley National Laboratory
Apr 15, 2016
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Membrane Specifications for Multi-Configuration Membrane Distillation Model
The data includes the membrane properties and specifications used for multi-configuration membrane distillation desalination. In this study, membranes from CLARCOR, 3M, and Aquastill are tested in counter-current, co-current and air-gap configurations at Colorado School of Mines (...
Villa, D. et al National Renewable Energy Laboratory
Mar 01, 2018
7 Resources
0 Stars
Publicly accessible
7 Resources
0 Stars
Publicly accessible
Utah FORGE: Earth Model Mesh Data for Selected Surfaces
This submission contains a number of data files with vertices of meshed/interpolated surfaces used in the Phase 2B earth model. Examples include land surface (based on 10-meter DEM), the granitoid-basin fill contact, several faults, and also interpolated temperature isosurfaces f...
Podgorney, R. Idaho National Laboratory
Dec 07, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
DASH Slow Strain Rates from Brady Hot Springs Geothermal Field during PoroTomo Deployment Period
This submission contains slow strain rates summed to radians over 30 second intervals [rad/s] derived from horizontal distributed acoustic sensing measurements (DASH) of Brady geothermal field during PoroTomo deployment (2016-Mar-14 to 2016-Mar-26). There is one file correspondin...
Reinisch, E. et al University of Wisconsin
Jun 27, 2018
20 Resources
0 Stars
Curated
20 Resources
0 Stars
Curated
Hydroshear Simulation Lab Test 2, Additional Data Sheets
This file contains additional data for this test (hydroshear test 3.2). In this test a sample of granite with a pre-cut (man made fracture) is confined, heated and differential stress is applied. The max temperature in this this system development test is 95C. More test details ca...
Bauer, S. Sandia National Laboratories
Aug 01, 2014
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Location Map
Map file package containing shaded relief base with Hot Pot project area, major roads, railroads, and rivers. The inset map shows regional Paleozoic structural elements.
Lane, M. Oski Energy LLC
Jun 27, 2013
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Proposed Drill Sites
Proposed drill sites for intermediate depth temperature gradient holes and/or deep resource confirmation wells. Temperature gradient contours based on shallow TG program and faults interpreted from seismic reflection survey are shown, as are two faults interpreted by seismic contr...
Lane, M. Oski Energy LLC
Jun 28, 2013
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Ground Motion Study Report
Paragon Geophysical contracted Urban Seismic Specialists to conduct A Ground Motion Study, on their Forge 3D project located near in Milford Utah .The test was conducted to measure the effects of the vibrator array on a pipeline owned by Kern River. Testing began November 22nd, an...
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 16, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Hawaii Play Fairway Analysis: Recharge Data for the Islands of Kauai, Lanai and Molokai, Hawaii
Recharge data for the islands of Kauai, Lanai and Molokai in shapefile format. These data are from the following sources:
Whittier, R.B and A.I. El-Kadi. 2014. Human Health and Environmental Risk Ranking of On-Site Sewage Disposal systems for the Hawaiian Islands of Kauai, Molo...
Lautze, N. University of Hawaii
Jan 01, 2015
12 Resources
0 Stars
Publicly accessible
12 Resources
0 Stars
Publicly accessible
EGS Collab Experiment 1: Time-series geochemistry data of the long-term circulation test
This submission presents the weekly geochemistry data of the long-term flow test performed within EGS Collab Experiment 1 from early 2019 to early 2020. The fluids from each producing borehole/interval (PI, PB, PDT and PST) along with the injectate were sampled roughly weekly from...
Zhang, Y. et al Stanford University
Jan 01, 2022
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
University of Illinois Campus Deep Direct-Use Feasibility Study Chemistry of Formation Waters
Studies of chemical composition of natural brines from rock formations in the Illinois Basin as part of the University of Illinois deep direct-use feasibility study.
Lin, Y. et al University of Illinois
Apr 23, 2018
6 Resources
0 Stars
Curated
6 Resources
0 Stars
Curated
Numerical Modeling for Hydraulic Fracture Prediction
Numerical modeling on fused silica cylindrical materials for predicting overpressures required to fracture an homogeneous pure (surrogate) material with known mechanical properties similar to igneous rock materials and later compare these values to experimental overpressures obtai...
Gupta, V. Pacific Northwest National Laboratory
Apr 26, 2016
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Conducting a 3D Converted Shear Wave Project to Reduce Exploration Risk at Wister, CA
2010 Peer Review of the 'Conducting a 3D Converted Shear Wave' Project to reduce exploration risk at Wister, CA. The presentation includes a timeline, budget, barriers, and partners. The objective of the project is also explained in the presentation.
Matlick, S. Ormat Nevada Inc
May 18, 2010
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Core Material Friction Experiments
The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Curated
7 Resources
0 Stars
Curated
Utah FORGE: Composite Raw Gravity Data 2021
This is a composite raw gravity dataset of the Utah FORGE area taken over time from December 2018 to to June 2021. The data shows differences in local gravity at different location across Utah FORGE. Included with the gravity data is the NAD83 UTM coordinates of each station in me...
Hardwick, C. Utah Geological Survey
Jun 04, 2021
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE: Geology Map and GIS Data
This archive contains a geology map of the general Roosevelt Hot Springs region, both in PDF and ArcGIS geodatabase formats, that was created as part of the Utah FORGE project.
Kirby, S. et al Energy and Geoscience Institute at the University of Utah
Mar 15, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Area Terrain Slope Data
This archive contains a terrain slope image, in units of degrees, of the Utah FORGE area near Roosevelt Hot springs. The data was derived from 0.5 m resolution LiDAR DEM data and is in a GeoTiff format. It was processed using ArcGIS.
Nash, G. Energy and Geoscience Institute at the University of Utah
Dec 10, 2018
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE 5-2615: Shear Enhanced Permeability In a Granitoid Fracture Presentation Slides
Provided here is a set of presentation slides detailing stress-dependent permeability in FORGE granitoid fractures and how fracture slip affects permeability. It outlines empirical correlations between permeability, stress, and fracture aperture, emphasizing that mechanically clos...
Ghassemi, A. and Ye, Z. University of Oklahoma
Feb 28, 2024
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Tularosa Basin Play Fairway Analysis: Weights of Evidence; Mineralogy, and Temperature Anomaly Maps
This submission has two shapefiles and a tiff image. The weights of evidence analysis was applied to data representing heat of the earth and fracture permeability using training sites around the Southwest; this is shown in the tiff image. A shapefile of surface temperature anomali...
Brandt, A. University of Utah
Nov 15, 2015
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible