Search GDR Data
Showing results 1 - 25 of 28.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
Following the successful stimulation of Desert Peak target EGS well 27-15, a circulation test was initiated by injecting a conservative tracer (1,5-nds) in combination with a reactive tracer (7-amino-1,3-naphthalene disulfonate). The closest production well 74-21 was monitored ove...
Includes data for measured inert tracer breakthrough curves first reported in Hawkins (2020) (Water Resources Research). In addition, this submission includes the production well temperature measurements first reported in Hawkins et al. (2017a) (Water Resources Research, volume 53...
This dataset contains tracer test results from stimulation and circulation experiments conducted on the Utah FORGE wells 16A(78)-32 and 16B(78)-32 during 2024. The data was collected by RESMAN Energy Technology and includes detailed tracer analysis from flowback, short and extende...
Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy.
Objective and Purpose:
Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...
This dataset contains the final technical report and closeout presentation for Utah FORGE Project 4-2492, which investigated advanced stimulation design and diagnostic approaches to improve fracture uniformity, inter-well connectivity, and energy recovery efficiency in enhanced ge...
This submission contains the presentation slides and recordings from the first 98 EGS Collab Modeling and Simulation Working Group teleconferences. These teleconferences served three objectives for the project: 1) share simulation results, 2) communicate field activities and resul...
This package includes data and models that support hydraulic fracture stimulation and fluid circulation experiments in the Sanford Underground Research Facility (SURF). A paper by Schwering et al. (2020) describes the deterministic basis for developing a "common" discrete fracture...
Subsurface data analysis, reservoir modeling, and machine learning (ML) techniques have been applied to the Brady Hot Springs (BHS) geothermal field in Nevada, USA to further characterize the subsurface and assist with optimizing reservoir management. Hundreds of reservoir simulat...
Plugging of fracture porosity from mineral precipitation due to injecting cold water into a a geothermal reservoir can impact the overall permeability of the fracture network in the reservoir. This can have serious ramifications on the efficiency of the geothermal resource. Geoche...
This submission contains pressure and flow time series data from the reservoir testing of Well 58-32. These activities were part of the Utah FORGE Phase 2B site suitability confirmatory testing.
Geothermal power plants typically show decreasing heat and power production rates over time. Mitigation strategies include optimizing the management of existing wells increasing or decreasing the fluid flow rates across the wells and drilling new wells at appropriate locations. Th...
This dataset contains trace element concentrations from fluid samples collected during the August-September 2024 circulation test at Utah FORGE. Samples were taken from injection well 16A(78)-32, production well 16B(78)-32, and monitoring well 58-32 on four dates between August 16...
Grid-scale energy storage has been identified as a needed technology to support the continued build-out of intermittent renewable energy resources. As of April 2017, the U.S. had approximately 24.2 GW of energy storage on line, compared to 1,081 GW of installed generation capacity...
USU Camas-1 is a geothermal test well drilled in Camas Prairie, Idaho, in the Summer and Fall of 2018. The purpose of this test well was to validate Play Fairway methodologies of the Snake River Plain Play Fairway Analysis project.
In this report, test data are analyzed to infer...
This report provides a first-order assessment of the producible energy from the Utah FORGE EGS reservoir, based on stimulation and circulation testing in 2024. The assessment is based on a stored heat calculation for a cylindrical volume of stimulated hot dry rock enveloping the d...
This archive contains data and a report from Pulse Interference Tests (PITs), which were conducted on September 4, 2024, immediately following a 30-day recirculation test at the Utah FORGE site. Injection and backflow were induced in well 16A(78)-32 while pressures were measured i...
This folder contains the GEOPHIRES codes and input files for running the base case scenarios for the six deep direct-use (DDU) projects. The six DDU projects took place during 2017-2020 and were funded by the U.S. Department of Energy Geothermal Technologies Office. They investiga...
Research references to literature about the Newberry geothermal area, Oregon.
Provided here is a set of presentation slides detailing stress-dependent permeability in FORGE granitoid fractures and how fracture slip affects permeability. It outlines empirical correlations between permeability, stress, and fracture aperture, emphasizing that mechanically clos...
This dataset contains wellhead pressure measurements for Utah FORGE wells 16A(78)-32 and 16B(78)-32 during two distinct shut-in periods. The first spans from September 2024 to April 2025, covering the interval between the conclusion of a 28-day circulation test and the start of a ...
This submission includes an Excel spreadsheet containing the Utah FORGE deep well 16A(78)-32 planned trajectory including UTM coordinates, elevations, and depths from the well head to the toe. This proposed new injection well is expected to descend vertically to a depth of approxi...
This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...
This preliminary data archive includes the relocated microseismic event catalog, 1D velocity model, and methods report from DAS acquisition conducted during the Well 16A and 16B circulation test (July 19th and 20th, 2023) at Utah FORGE. The methods report describes all processing ...
This data archive includes the relocated microseismic event catalog from distributed acoustic sensing (DAS) acquisition conducted during the 16A-16B circulation tests that took place in July 2023. These results update the catalog presented in GDR 1613 (the preliminary catalog, lin...
This is the topical report that wraps up the work and results achieved during Utah FORGE Phase 2C. The zip file includes several folders containing (1) an overview; (2) the results; (3) the lessons learned; and (4) the conclusions. It also contains a folder containing appendices i...
Google Map