Search GDR Data

Utah FORGE: Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics

Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and ...

Eijsink, A. and Elsworth, D. Pennsylvania State University

Jul 08, 2022
2 Resources
0 Stars
Curated

Utah FORGE: Temperature-Dependent Fracture Seismicity from Fluid Injection Experiments

This dataset contains experimental data from fluid injection experiments conducted to investigate the influence of temperature on fracture seismicity. The experiments were performed on granite samples from Utah FORGE. The samples were prepared with a 30-degree inclined fracture an...

Wang, J. et al Pennsylvania State University

Feb 29, 2024
4 Resources
0 Stars
Curated

Utah FORGE: Roosevelt Hot Springs Analytical Well-Based Temperature Model Data

This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corre...

Podgorney, R. and Allis, R. Idaho National Laboratory

Dec 07, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 56-32 Drilling Data and Logs

This dataset consists of drilling data (Pason data spreadsheets, daily reports, days v. depth, mud logs), Schlumberger logs (FMI, shear anisotropy analysis, memory, sonic, array induction/spectral density/dual spaced neutron/gamma ray/caliper, spectral GR/temperature, and Gardner ...

Bristol, J. et al Energy and Geoscience Institute at the University of Utah

Mar 19, 2021
18 Resources
0 Stars
Publicly accessible

EGS Collab: Modeling and Simulation Working Group Teleconference Series (129-130)

This submission contains the presentation slides and recordings from EGS Collab Modeling and Simulation Working Group (MSWG) teleconferences number 129 through 130. These teleconferences served three objectives for the project: 1) share simulation results, 2) communicate field act...

White, M. et al Pacific Northwest National Laboratory

Jun 22, 2022
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Well Data for Student Competition

Well 58-32 (previously labeled MU-ESW1) was drilled near Milford Utah during Phase 2B of the FORGE Project to confirm geothermal reservoir characteristics met requirements for the final FORGE site. Well Accord-1 was drilled decades ago for geothermal exploration purposes. While ...

Podgorney, R. et al Idaho National Laboratory

Dec 07, 2018
12 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...

Yu, J. et al Pennsylvania State University

Jul 01, 2023
27 Resources
0 Stars
Curated

Utah FORGE 2-2439: A Multi-Component Approach to Characterizing In-Situ Stress: Laboratory, Modeling and Field Measurement Workshop Presentation

This is a presentation on A Multi-Component Approach to Characterizing In-Situ Stress at the U.S DOE FORGE EGS Site: Laboratory, Modeling and Field Measurement project by Battelle [Columbus, OH], presented by Mark Kelley. The project's objective was to characterize stress in the U...

Kelley, M. and Bunger, A. Battelle Memorial Institute

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2615: Well 58-32 and 78-32 Poroelastic Properties

Lab data on permeability, grain bulk modulus, drained bulk modulus, Skempton's pore pressure coefficient, and Biot's effective stress coefficient for Utah Forge Well 58-32 and Well 78-32. Work done as part of project number 5-2615 by the University of Oklahoma.

Ghassemi, A. and Zhou, X. University of Oklahoma

Oct 31, 2022
2 Resources
0 Stars
Curated

Utah FORGE: Wells 16A(78)-32 and 16B(78)-32 Stimulation Pressure and Circulation Data April, 2024

This dataset consists of all of the pressure pumping data for Utah FORGE Well16A78-32 fracturing stages, Well 16B78-32 fracturing stages, and a 9-hour circulation test which took place after all of the frac plugs were drilled out. Fracturing in the wells took place in stages from ...

England, K. Energy and Geoscience Institute at the University of Utah

Jun 03, 2024
4 Resources
0 Stars
Curated

Utah FORGE: Well 16A(78)-32/Well16B(78)-32 Circulation Test Data

This dataset encompasses the collected data and associated reports from the low-rate injection circulation test conducted on wells 16A(78)-32 and 16B(78)-32 in July 2023 at Utah FORGE. It includes comprehensive raw circulation data, captured by Pason and Schlumberger (SLB). The da...

Mclennan, J. and Xing, P. Energy and Geoscience Institute at the University of Utah

Jul 19, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...

Kazemi, H. et al Colorado School of Mines

Aug 04, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...

Jeppson, T. and Lockner, D. United States Geological Survey

Feb 24, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Phase 2C Seismic Observation and Ground Water Well Data and Well Locations

This submission contains the following data associated with Utah FORGE Phase 2C within the Roosevelt Hot Springs geothermal area: An ArcGIS shapefile with well locations for wells 58-32, 78-32, 68-32, OH-3, OH-4, WOW-2, and WOW-3. Well 58-32 is the deep test well, wells 68-32 an...

Abraham, S. et al Energy and Geoscience Institute at the University of Utah

Mar 26, 2019
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment

Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...

Roseboom, M. et al Pennsylvania State University

Nov 07, 2023
6 Resources
0 Stars
Curated

Utah FORGE: Well 78B-32 Daily Drilling Reports and Logs

This data set includes the daily drilling reports and Pason data for well 78B-32 and Schlumberger logs acquired after drilling completion. This well was drilled between June 27th and July 31st of 2021. Also included is raw and processed data for a variety of well data metrics incl...

McLennan, J. Energy and Geoscience Institute at the University of Utah

Aug 09, 2021
22 Resources
0 Stars
Curated

Utah FORGE: Well 58-32 Injection Test Data

This submission contains pressure and flow time series data from the reservoir testing of Well 58-32. These activities were part of the Utah FORGE Phase 2B site suitability confirmatory testing.

Podgorney, R. and McLennan, J. Idaho National Laboratory

Dec 07, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Pump and Probe Test on a Mated Fracture Westerly Granite Sample

This dataset contains results from a pump and probe experiment conducted on a mated fracture Westerly Granite sample with a diameter of 1 inch and a height of 2 7/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-line...

Klinghammer, H. et al Pennsylvania State University

May 19, 2024
4 Resources
0 Stars
Curated

Utah FORGE: Neubrex Well 16B(78)-32 Stimulation Fiber Optic Monitoring Reports April and May, 2024

These reports contain information on the distributed temperature sensing (DTS), distributed strain sensing (DSS), and pressure monitoring during the stimulation of Well 16(B)78-32 at Utah FORGE, in April and May 2024. Reports include information on data collection and calibrations...

Jurick, D. and Guzik, D. Neubrex Energy Services (US), LLC

Apr 30, 2024
3 Resources
0 Stars
Curated

Utah FORGE: Data for 3-D Model Development Lithology, Temperature, Pressure, and Stress

This submission comprises two downloadable .zip archives. Each archive contains spreadsheets with 3-D data and a .txt document describing the data. The Mesh Files .zip download contains data regarding the lithologic contacts of the granitoid and overlying sedimentary basin fill. T...

Podgorney, R. Idaho National Laboratory

Mar 17, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase Native State FALCON Model Files

The submission includes FALCON input file and mesh for the an initial pressure-temperature simulation, and a second set for pressure-temperature-displacement simulation. All simulations are steady state. Data and input for the FORGE Phase 2 native state model were compiled from hi...

Podgorney, R. Idaho National Laboratory

Jun 06, 2019
2 Resources
0 Stars
Curated

Utah FORGE: 2019 ARMA Overview Slide Presentation

This is an overview presentation of the Utah FORGE project given by Joseph Moore, Ph.D., at the 2019 American Rock Mechanics Associate meeting. It details the state of the Utah FORGE project at on 8/17/2019.

Moore, J. Energy and Geoscience Institute at the University of Utah

Aug 17, 2019
1 Resources
0 Stars
Publicly accessible

Utah FORGE 2-2446: Report on Laboratory Block Experiments with Six Different Combinations of Stresses and Rock Fabrics

This report documents a series of block-scale hydraulic fracturing experiments, simulating Utah FORGE conditions to investigate how different combinations of in situ stress regimes, well orientations, and thermal stress conditions influence fracture initiation and propagation. The...

Bunger, A. and Lu, Y. Lawrence Livermore National Laboratory

Jan 30, 2025
1 Resources
0 Stars
Curated

Utah FORGE 3-2417: Meteorological Data During 2024 Stimulation

This preliminary data archive includes meteorological data recorded at the Utah FORGE facility over the period of time including the 16A/16B stimulation activities, largely March/April/May of 2024. This information may prove useful for understanding seismic and other instrumentati...

Ajo-Franklin, J. Rice University

May 09, 2024
5 Resources
0 Stars
Curated

Utah FORGE: Well 16A(78)-32: Summary of Drilling Activities

This is a 74 page detailed summary of the drilling activities of Utah FORGE 16A(78)-32, a highly deviated well completed on February 2nd, 2021, as part of the Utah FORGE project. This well was deviated at 65 degrees from vertical after reaching 6000 feet in depth had a total measu...

Winkler, D. et al Energy and Geoscience Institute at the University of Utah

Mar 20, 2021
1 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 Next >>