Search GDR Data

Utah FORGE: Phase 3 Microgravity Data

A 4D microgravity survey began in early 2019 in order to benchmark surface and subsurface elevations prior to Phase 3 drilling and stimulation campaigns. Microgravity stations are collocated with GPS deformation benchmarks and use the same location survey data. Surveys are underta...

Hardwick, C. Utah Geological Survey

Oct 07, 2020
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Sanvean Technologies Drilling Data from Well 16B(78)-32

Included here is Sanvean Technologies bit sensor data amalgamated with data from National Oilwell Varco's (NOV) BlackBox tool for Reed Hycalog bits used during drilling of Well 16B(78)-32. The dataset contains information collected at the bit while drilling including rate of penet...

Barker, C. Energy and Geoscience Institute at the University of Utah

Oct 26, 2023
5 Resources
0 Stars
Publicly accessible

Utah FORGE: Fiber Optic Cumulative Strain Change and Strain Change Rate Data From Well 16A Stimulation at Well 16B

This dataset includes Rayleigh Frequency Shift (RFS) Distributed Strain Sensing (DSS) cumulative strain change and change rate data. The data was acquired during the stimulation of Utah FORGE Well 16A(78)-32 in April 2024 via fiber installed in Well 16B(78)-32. The fiber optic da...

Khatara, S. et al Neubrex Energy Services (US), LLC

Nov 06, 2024
2 Resources
0 Stars
Curated

A Conceptual Geologic Model for the Newberry Volcano EGS Site in Central Oregon: Constraining Heat Capacity and Permeability through Interpretation of Multicomponent Geosystems Data

Newberry Volcano, a voluminous (500 km3) basaltic/andesitic/rhyolitic shield volcano located near the intersection of the Cascade volcanic arc, the Oregon High Lava Plains and Brothers Fault Zone, and the northern Basin and Range Province, has been the site of geothermal explorati...

Mark-Moser, M. et al National Energy Technology Laboratory

Feb 22, 2016
1 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...

Gritto, R. Array Information Technology

Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

Brady's Geothermal Field Active Source Seismic Survey MetaData

Sweep parameters, source locations and trigger timing for the four Phases of active source seismic data acquisition.

Robertson, M. University of Wisconsin

Mar 28, 2016
2 Resources
0 Stars
Publicly accessible

Utah FORGE 2439: Machine Learning for Well 16A(78)-32 Stress Predictions September 2023 Report

This task completion report documents the development and implementation of machine learning (ML) models for the prediction of in-situ vertical (Sv), minimum horizontal (SHmin) and maximum horizontal (SHmax) stresses in well 16A(78)-32. The detailed description of the experimental...

Mustafa, A. et al Battelle Memorial Institute

Sep 28, 2023
3 Resources
0 Stars
Curated

Newberry EGS Literature References

Research references to literature about the Newberry geothermal area, Oregon.

Rose, K. National Energy Technology Laboratory

Apr 22, 2016
1 Resources
0 Stars
Publicly accessible

Regional Slip Tendency Analysis of the Great Basin Region

Slip and dilation tendency on the Great Basin fault surfaces (from the USGS Quaternary Fault Database) were calculated using 3DStress (software produced by Southwest Research Institute). Slip and dilation tendency are both unitless ratios of the resolved stresses applied to the f...

E., J. University of Nevada

Sep 30, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Optimization of a Plug-and-Perf Stimulation (Fervo Energy)

Information around the plug-and-perf treatment design at Utah FORGE by Fervo Energy. Objective and Purpose: Develop a multistage hydraulic stimulation approach designed specifically to target the top three factors that control the technical and commercial viability of an EGS sys...

Norbeck, J. et al Fervo Energy

Feb 08, 2023
3 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE: Magnetotelluric 3D Data

This is the 3D version of the MT data for the West Flank Coso FORGE area. The Coso geothermal field has had three Magnetotelluric (MT) datasets collected including surveys in 2003, 2006, and 2011. The final collection, in 2011, expanded the survey to the west and covers the West F...

Blankenship, D. Sandia National Laboratories

Jan 01, 2016
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 78-32 Capacity Test

This dataset includes an Excel spreadsheet with Utah FORGE Phase 2c Well 78-32 capacity data. It also includes a readme file discussing the data which also includes the well coordinates.

Kirby, S. and Gall, R. Energy and Geoscience Institute at the University of Utah

Jun 20, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Regional Well Locations

This archive contains a GIS point feature shapefile that shows the locations of wells in the general region of the Utah FORGE project, near Roosevelt Hot Springs. This includes Utah FORGE deep well 58-32 and wells for which data has been uploaded to the Geothermal Data Repository....

Nash, G. Energy and Geoscience Institute at the University of Utah

Feb 22, 2018
1 Resources
0 Stars
Publicly accessible

WISE-CASING: Surface Seismic Survey at Cymric Field, California Central Valley

This test was conducted at the Chevron Cymric oilfield in the California central valley near Bakersfield. A reflected seismic signal was observed in all three components (x, y, z) of the 3-component Episensor geophone, as well as all phones on the single component array. The arriv...

Wu, Y. et al Lawrence Berkeley National Laboratory

Apr 02, 2018
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Temperature Gradient Database

This is a temperature gradient database for Utah, USA. It is located at the Utah Geological Survey. This contains data relevant to the Utah FORGE project.

Nash, G. Energy and Geoscience Institute at the University of Utah

Feb 01, 2004
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Hydraulic Fracturing Stage 8 Crosswell Strain FDI and Microseismic Presentations April 2024

This is a pair of PowerPoint presentations from Neubrex Energy Services (US), LLC. The presentations review work done in April 2024 on crosswell strain fracture driven interactions (FDI) and microseismic event monitoring during hydraulic fracturing in stage 8 of Utah FORGE well 16...

Jurick, D. et al Neubrex Energy Services (US), LLC

Nov 07, 2024
1 Resources
0 Stars
Curated

EGS Collab Experiment 1: Temperature profile

This submission includes an input file, plot file, Fortran conversion file, and 3D data file from the simulation of the temperature profile within the Test Bed #1 of the EGS Collab project. The simulation was executed with PNNL's STOMP-GT simulator, which reads the input file, and...

White, M. Pacific Northwest National Laboratory

Apr 01, 2019
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Wells Updated Temperature and Pressure Logs (June 2021)

This dataset includes updated temperature and pressure logs for Utah FORGE wells 56-32, 78-32, and 58-32. This data was acquired in June 2021.

Stout, F. Di Drill Survey Services

Jun 29, 2021
4 Resources
0 Stars
Curated

Utah FORGE: Deep Wells Temperature Surveys as of September 2022

This Excel spreadsheet contains temperature survey results for Utah FORGE wells 58-32, 78-32, 56-32, 16A(78)-32 and 78B-32. It also contains charts and comparisons, along with a "Data Summary" which provides links to previous GDR submissions with temperature data for each well.

Jones, C. Energy and Geoscience Institute at the University of Utah

Sep 16, 2022
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Distributed Fiber Optic Temperature Data (DTS)

Distributed fiber optic sensing was an important part of the monitoring system for EGS Collab Experiment #2. A single loop of custom fiber package was grouted into the four monitoring boreholes that bracketed the experiment volume. This fiber package contained two multi-mode fiber...

Rodriguez Tribaldos, V. et al Lawrence Berkeley National Laboratory

Nov 08, 2022
10 Resources
0 Stars
Publicly accessible

Utah FORGE: Temperature Contours

This submission contains several ArcGIS shapefiles, each with Temperature contour lines at different depths. Subsurface temperature were important for characterizing the geothermal system beneath the FORGE site in Milford, Utah.

Moore, J. Energy and Geoscience Institute at the University of Utah

Mar 09, 2016
5 Resources
0 Stars
Publicly accessible

Utah FORGE: LBNL Reports on VEMP Electromagnetic Data Collection and Processing 2024

This archive contains reports related to Vertical Electromagnetic Profiling (VEMP) tool data collection and processing at Utah FORGE in 2024. The first report describes LBNL's effort to collect electromagnetic geophysical data with the tool in well 78-32B and a downhole electrode ...

Alumbaugh, D. et al Los Alamos National Laboratory

Mar 02, 2025
1 Resources
0 Stars
Curated

Deep Direct-Use Feasibility Study Temperature-Depth Estimates for West Virginia University, Morgantown, WV

This dataset contains data spreadsheets and figures that summarize the results of a stochastic analysis of temperatures at depth below the West Virginia University campus in Morgantown, WV. These results are extracted from a study by Smith (2019), whose results are included in a G...

Smith, J. West Virginia University

Dec 19, 2019
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Milford Deep Test Well 58-32 (MU-ESW1) Pressure and Temperature Logs

This archive consists of a pdf graphic log and a LAS text file representing the results of the pressure and temperature logs measured on Nov. 8th, 2018 from the Utah FORGE deep test well 58-32 (MU-ESW1). The logs were taken by DI Drill Survey Services.