Search GDR Data

Utah FORGE 2-2446: Characterizing Stress Roughness Through Simulation of Hydraulic Fracture Growth

This dataset covers work that investigated the apparent toughness anisotropy at Utah FORGE by comparing microseismic data with stress profiles from field measurements. The study analyzes the hydraulic fracture growth of Stage 3 at Well 16A(78)-32 using MEQ data, calibrating a nume...

Cusini, M. and Fei, F. Lawrence Livermore National Laboratory

Jan 30, 2025
3 Resources
0 Stars
Publicly accessible

Cape EGS and Utah FORGE: Empirical 3D Seismic Velocity Model

This dataset provides an empirical three-dimensional P and S-wave velocity model covering a 30 x 30 km area and extending to 10 km depth around the Cape Modern EGS and Utah FORGE sites. It incorporates three-dimensional topography and a sediment/basement contact derived from geoph...

Nakata, N. et al Lawrence Berkeley National Laboratory

Nov 12, 2025
3 Resources
0 Stars
Curated

Utah FORGE: Direct Shear Tests on Saturated Sierra White Granite Joints at Elevated Temperatures

This dataset contains results from laboratory direct shear experiments performed on tension-induced fractures in Sierra White granite under saturated conditions at target temperatures of 50 C and 100 C. The data were collected using a custom water-pressurized chamber equipped with...

Han, K. et al Purdue University

Nov 24, 2025
2 Resources
0 Stars
Curated

EGS Collab Experiment 2: Continuous Active Source Seismic Monitoring (CASSM)

The dataset contains continuous active-source seismic monitoring (CASSM) data collected during EGS Collab Experiment 2, conducted from February to September 2022 at the Sanford Underground Research Facility in Lead, South Dakota. This experiment aimed to investigate enhanced geoth...

Hopp, C. et al Lawrence Berkeley National Laboratory

Jan 06, 2025
3 Resources
0 Stars
Publicly accessible

Effective Elastic and Neutron Capture Cross Section Calculations Corresponding to Simulated Fluid Properties from CO2 Push-Pull Simulations

The submission contains a .xls files consisting of 10 excel sheets, which contain combined list of pressure, saturation, salinity, temperature profiles from the simulation of CO2 push-pull using Brady reservoir model and the corresponding effective compressional and shear velocity...

Chugunov, N. and Altundas, B. Lawrence Berkeley National Laboratory

Mar 07, 2018
1 Resources
0 Stars
Publicly accessible

EGS Collab: 3D Geophysical Model Around the Sanford Underground Research Facility

This package contains data associated with a proceedings paper (linked below) submitted to the 44th Workshop on Geothermal Reservoir Engineering. The Geophysical Model text file contains density, P and S-wave seismic speeds on a 3D grid. The file has six columns and provides latit...

Chai, C. et al Lawrence Berkeley National Laboratory

Feb 06, 2019
3 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: SIMFIP Notch-164 GRL Paper

Characterizing the stimulation mode of a fracture is critical to assess the hydraulic efficiency and the seismic risk related to deep fluid manipulations. We have monitored the three-dimensional displacements of a fluid-driven fracture during water injections in a borehole at ~1.5...

Guglielmi, Y. Lawrence Berkeley National Laboratory

Sep 24, 2020
9 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...

Um, E. et al Lawrence Berkeley National Laboratory

Feb 06, 2023
4 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...

Ingraham, M. et al Sandia National Laboratories

Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2417: Low Frequency Distributed Acoustic Sensing Data from 16A/16B Stimulation April, 2024

This dataset contains processed low-frequency Distributed Acoustic Sensing (LF-DAS) data collected between April 2 and April 12, 2024, during the Utah FORGE stimulation sequence involving wells 16A and 16B. The DAS measurements were acquired using a Silixa Carina interrogator unit...

Zhu, R. et al Rice University

Jul 23, 2025
7 Resources
0 Stars
Curated

Distributed Acoustic Sensing (DAS) of Strain at Earth Tide Frequencies: Laboratory Tests

The solid Earth strains in response to the gravitational pull from the Moon, Sun, and other planetary bodies. Measuring the flexure of geologic material in response to these Earth tides provides information about the geomechanical properties of rock and sediment. Such measurements...

Coleman, T. and Becker, M. California State University

Jan 24, 2018
2 Resources
0 Stars
Curated

EGS Collab Experiment 1: Continuous Active-Source Seismic Monitoring (CASSM) Data

The U.S. Department of Energy's Enhanced Geothermal System (EGS) Collab project aims to improve our understanding of hydraulic stimulations in crystalline rock for enhanced geothermal energy production through execution of intensely monitored meso-scale experiments. The first expe...

Schoenball, M. and Sprinkle, P. Lawrence Berkeley National Laboratory

Apr 25, 2018
6 Resources
1 Stars
Publicly accessible

EGS Collab Experiment 2: Distributed Fiber Optic Temperature Data (DTS)

Distributed fiber optic sensing was an important part of the monitoring system for EGS Collab Experiment #2. A single loop of custom fiber package was grouted into the four monitoring boreholes that bracketed the experiment volume. This fiber package contained two multi-mode fiber...

Rodriguez Tribaldos, V. et al Lawrence Berkeley National Laboratory

Nov 08, 2022
10 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Compilation of Geodetic Data and Estimation of Associated Deformation

Report on possible geodetic signature of the 3 stimulations in April 2022 as well as a comparison with existing InSAR data gathered over the site before, during, and after the stimulation. In geothermal production it is important to understand the existing stress field and the cha...

Vasco, D. et al Lawrence Berkeley National Laboratory

Apr 29, 2022
4 Resources
0 Stars
Publicly accessible

WISE-CASING: Surface Seismic Survey at Cymric Field, California Central Valley

This test was conducted at the Chevron Cymric oilfield in the California central valley near Bakersfield. A reflected seismic signal was observed in all three components (x, y, z) of the 3-component Episensor geophone, as well as all phones on the single component array. The arriv...

Wu, Y. et al Lawrence Berkeley National Laboratory

Apr 02, 2018
6 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Core Logs

Core logs and photos from the EGS Collab project Experiment 2 for the Top Vertical well (TV4100) and the Top Horizontal well (TV 4100) on the 4100 Level of SURF (the Sanford Underground Research Facility). The core logs are stored in a single PDF file with 5-ft run intervals. In t...

Dobson, P. et al Lawrence Berkeley National Laboratory

Jul 08, 2019
7 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements

The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...

Alumbaugh, D. et al Lawrence Berkeley National Laboratory

Dec 01, 2022
5 Resources
0 Stars
Publicly accessible

Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis

Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...

Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory

Mar 09, 2018
11 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2514: Strain Sensing Array for Deformation Characterization 2024 Annual Workshop Presentation

This is a presentation on the Strain Sensing Array to characterize deformation at the FORGE site project by Clemson University, presented by Lawrence Murdoch. The project's objective was to evaluate the feasibility of measuring and interpreting tensor strain data to improve the pe...

Murdoch, L. et al Energy and Geoscience Institute at the University of Utah

Aug 13, 2024
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Circulation Testing Processed data

This submission includes processed and reduced data for circulation testing that was conducted at the 164' fracture on the 4850 ft level of the Sanford Underground Research Facility. The circulation tests were done to test the flow through the 164' fracture in the EGS Collab Exper...

Fu, P. et al Lawrence Livermore National Laboratory

Apr 01, 2021
7 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Circulation Testing

These data and test descriptions comprise a chilled circulation test conducted at the 164' fracture in the EGS Collab Experiment 1 testbed on the 4850 ft level of the Sanford Underground Research Facility. Descriptions of the meta data, design drawings for the flow testing system,...

Knox, H. et al Lawrence Berkeley National Laboratory

Apr 01, 2019
11 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: In-situ observation of pre-, co and post-seismic shear slip preceding hydraulic fracturing

Understanding the initiation and arrest of earthquakes is one of the long-standing challenges of seismology. Here we report on direct observations of borehole displacement by a meter-sized shear rupture induced by pressurization of metamorphic rock at 1.5 km depth. We observed the...

Guglielmi, Y. et al Lawrence Berkeley National Laboratory

May 22, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2514: A Strain Sensing Array to Characterize Deformation at the FORGE Site Workshop Presentation

This is a presentation on the Strain Sensing Array to Characterize Deformation at the FORGE Site project by Clemson University, presented by Lawrence Murdoch. The project's objective was to evaluate the feasibility of measuring and interpreting tensor strain data to improve the pe...

Murdoch, L. et al Clemson University

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2514: A Strain Sensing Array to Characterize Deformation at the FORGE Site 2025 Workshop Presentation

Murdoch, L. Clemson University

Sep 18, 2025
3 Resources
0 Stars
Curated

kISMET Core Photos and Descriptions

These core photos and descriptions were taken from the five boreholes that were drilled as part of the kISMET SubTER project conducted at the Sanford Underground Research Facility (SURF) in Lead, SD. The boreholes are subvertical in orientation, and were drilled on the 4850 level ...