Search GDR Data

Validation of Innovative Exploration Technologies for Newberry Volcano: Raw Gravity Data

Validation of Innovative Exploration Technologies for Newberry Volcano: Raw data used to prepare the Gravity Report by Zonge 2012

Jaffe, T. Davenport Newberry Holdings, LLC

Oct 11, 2010
2 Resources
0 Stars
Publicly accessible

STRESSINVERSE Software for Stress Inversion

The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts the strike, rake and dip from moment tensor solutions for the in-situ state of stress. The code iteratively solves...

Gritto, R. Array Information Technology

Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 Post Hydraulic Fracturing 9 Hour Dual Well Circulation Test Fiber Optic Monitoring Report April 2024

This report examines the fiber optic measurements made on the Utah FORGE well 16B(78)-32 after it and well 16A(78)-32 were hydraulically stimulated and shortly thereafter a 9 hour cross well circulation test was run between them. The report reviews distributed fiber optic signal p...

Guzik, A. and Davidson, E. Neubrex Energy Services (US), LLC

Apr 27, 2024
1 Resources
0 Stars
Curated

Utah FORGE 2-2446: Report on Laboratory Block Experiments with Six Different Combinations of Stresses and Rock Fabrics

This report documents a series of block-scale hydraulic fracturing experiments, simulating Utah FORGE conditions to investigate how different combinations of in situ stress regimes, well orientations, and thermal stress conditions influence fracture initiation and propagation. The...

Bunger, A. and Lu, Y. Lawrence Livermore National Laboratory

Jan 30, 2025
1 Resources
0 Stars
Curated

Newberry EGS Demonstration: Initial Project Report and Induced Seismicity Mitigation Plan, 2011

This is the first project report and induced seismicity mitigation plan for the Newberry Enhanced Geothermal Systems (EGS) Demonstration project. The primary objectives of this first phase were to obtain necessary permits and comply with all regulations, including NEPA, communica...

Cladouhos, T. et al AltaRock Energy Inc

May 05, 2024
4 Resources
0 Stars
Curated

Brady's Geothermal Field Active Source Seismic Survey MetaData

Sweep parameters, source locations and trigger timing for the four Phases of active source seismic data acquisition.

Robertson, M. University of Wisconsin

Mar 28, 2016
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 Stimulation Hydraulic Fracturing In-Well DAS Fiber Optic Monitoring Report April 2024

The report reviews results obtained by Neubrex using Distributed Acoustic Sensing (DAS) during the 16B(78)-32 hydraulic fracturing operations, Stages 1–4. It details DAS data acquisition, processing, and analysis, with a focus on acoustic noise signatures recorded during each st...

Jurick, D. et al Neubrex Energy Services (US), LLC

Apr 26, 2024
1 Resources
0 Stars
Curated

Utah FORGE: Well 16B(78)-32 Extended Dual Well Circulation Testing Fiber Optic Monitoring Report August 2024

This report documents the post-hydraulic fracturing extended circulation test between Utah FORGE wells 16A and 16B conducted in August 2024. In well 16B, fiber optic measurements of Rayleigh frequency shift distributed strain sensing (RFS-DSS) and distributed temperature sensing ...

Jurick, D. et al Neubrex Energy Services (US), LLC

Aug 30, 2024
1 Resources
0 Stars
Curated

Utah FORGE 3-2535: Preliminary Report on Development of a Reservoir Seismic Velocity Model

This report describes the development of a preliminary 3D seismic velocity model at the Utah FORGE site and first results from estimating seismic resolution in the generated fracture volume during Stage 3 of the April 2022 stimulation. A preliminary 3D velocity model for the larg...

Gritto, R. Array Information Technology

Jan 30, 2023
1 Resources
0 Stars
Curated

Utah FORGE: Hydraulic Fracture Width Determination Using Stoneley Wave Pressure Testing and Electrical Borehole Scans

This report provides insights into Utah FORGE well 58-32's hydraulic fractures. It utilizes both electrical borehole scans from Schlumberger's Formation Micro-scanner Image tool (FMI) and Stoneley waves from a borehole sonic tool. These methods are combined in a comprehensive work...

Hornby, B. Hornby Geophysical Services, LLC

Oct 06, 2023
1 Resources
0 Stars
Publicly accessible

Devices Suitable for Sectional Isolation Along Both Cased and Open-hole Wellbores Pipe Preparation Report

The main goal of this project is to develop an annular isolation system capable to withstand geothermal downhole conditions and mitigate the problems experienced by conventional packers in FORGE wells. This pipe preparation report is based on the test pipe that was procured and pr...

Teodoriu, C. et al Welltec

Mar 31, 2023
2 Resources
0 Stars
Publicly accessible

Brady's Geothermal Field Analysis of Pressure Data

*This submission provides corrections to GDR Submissions 844 and 845* Poroelastic Tomography (PoroTomo) by Adjoint Inverse Modeling of Data from Hydrology. The 3 *csv files containing pressure data are the corrected versions of the pressure dataset found in Submission 844. The ...

Lim, D. University of Wisconsin

Mar 17, 2017
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Milford Digitized Geophysical Logs from Acord 1

This submission includes digitalized versions of the following: McCulloch Geothermal Corp Acord 1-26 Cover Letter McCulloch Geothermal Corp Acord 1-26 Drilling Plan McCulloch Geothermal Corp Acord 1-26 Bond Documents Division of Water Rights Permission to Drill Drillers Log Geot...

Jones, C. and Moore, J. Energy and Geoscience Institute at the University of Utah

Mar 31, 2016
1 Resources
0 Stars
Publicly accessible

Chlorite Dissolution Kinetics at Variable pH and Temperatures up to 275C

FY13 annual report describing the calculations and results associated with the data and dissolution rate contained in "Chlorite Kinetic Dissolution Data and Rate" (linked below).

Carroll, S. and Smith, M. Lawrence Livermore National Laboratory

Oct 01, 2013
2 Resources
0 Stars
Publicly accessible

Newberry EGS Literature References

Research references to literature about the Newberry geothermal area, Oregon.

Rose, K. National Energy Technology Laboratory

Apr 22, 2016
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Distributed Fiber Optic Temperature Data (DTS)

Distributed fiber optic sensing was an important part of the monitoring system for EGS Collab Experiment #2. A single loop of custom fiber package was grouted into the four monitoring boreholes that bracketed the experiment volume. This fiber package contained two multi-mode fiber...

Rodriguez Tribaldos, V. et al Lawrence Berkeley National Laboratory

Nov 08, 2022
10 Resources
0 Stars
Publicly accessible

Sustainable Self-Propping Shear Zones in EGS: Chlorite, Illite, and Biotite Rates and Report

Spreadsheet containing chlorite, illite, and biotite rate data and rate equations that can be used in reactive transport simulations. Submission includes a report on the development of the rate laws.

Carroll, S. and Smith, M. Lawrence Livermore National Laboratory

Nov 06, 2015
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2557: Trixial Shear and Wellbore Breakout Tests Report and Data

Included are a report and data from triaxial shear tests on simulated Sierra White fault gouge and a borehole stimulation experiment. This serves as a progress report for the Role of Fluid and Temperature in Fracture Mechanics and Coupled Thermo-Hydro-Mechanical-Chemical (THMC) P...

Choens, C. and Yoon, H. Sandia National Laboratories

Apr 19, 2023
2 Resources
0 Stars
Publicly accessible

Regional Slip Tendency Analysis of the Great Basin Region

Slip and dilation tendency on the Great Basin fault surfaces (from the USGS Quaternary Fault Database) were calculated using 3DStress (software produced by Southwest Research Institute). Slip and dilation tendency are both unitless ratios of the resolved stresses applied to the f...

E., J. University of Nevada

Sep 30, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Ground Motion Study Report

Paragon Geophysical contracted Urban Seismic Specialists to conduct A Ground Motion Study, on their Forge 3D project located near in Milford Utah .The test was conducted to measure the effects of the vibrator array on a pipeline owned by Kern River. Testing began November 22nd, an...

Moore, J. Energy and Geoscience Institute at the University of Utah

Mar 16, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone

Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...

Um, E. et al Lawrence Berkeley National Laboratory

Feb 06, 2023
4 Resources
0 Stars
Curated

Utah FORGE 2439: Report on Minifrac Tests for Stress Characterization

This report describes minifrac tests conducted in the 16B(78)-32 well at the Utah FORGE site to characterize subsurface stresses, including the magnitude and orientation of the minimum and maximum horizontal stresses and the magnitude of the vertical stress. A minifrac test was co...

Kelley, M. et al Battelle Memorial Institute

Feb 22, 2024
1 Resources
0 Stars
Curated

Utah FORGE: Neubrex Well 16B(78)-32 Stimulation Fiber Optic Monitoring Reports April and May, 2024

These reports contain information on the distributed temperature sensing (DTS), distributed strain sensing (DSS), and pressure monitoring during the stimulation of Well 16(B)78-32 at Utah FORGE, in April and May 2024. Reports include information on data collection and calibrations...

Jurick, D. and Guzik, D. Neubrex Energy Services (US), LLC

Apr 30, 2024
3 Resources
0 Stars
Curated

Utah FORGE: Seismic Risk Trafic Light System Version 2

The report outlines the updated Traffic Light System (TLS) for the Utah FORGE project, which aims to mitigate seismic risks associated with Enhanced Geothermal Systems (EGS) operations. It integrates lessons from past operations, including stimulation and circulation experiments a...

Pankow, K. et al University of Utah Seismograph Stations

Jan 24, 2025
1 Resources
0 Stars
Curated

Utah FORGE 3-2535: Numerical Modeling of Energized Steel-Casing Source for Imaging Stimulated Zone

This short report details and tests the workflow that will be used to simulate steel well casings in deviated production/extraction boreholes at at the Utah FORGE site. Boreholes will be electrically energized and will serve as data sources for future proposed electromagnetic bore...