Search GDR Data
Showing results 1 - 25 of 57.
Show
results per page.
Order by:
Available Now:
Technologies
Featured Projects
Topics
Data Type
Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments
Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...
Jeppson, T. and Lockner, D. United States Geological Survey
Feb 24, 2022
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE: Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics
Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and ...
Eijsink, A. and Elsworth, D. Pennsylvania State University
Jul 08, 2022
2 Resources
0 Stars
Curated
2 Resources
0 Stars
Curated
Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments
Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite.
All expe...
Yu, J. et al Pennsylvania State University
Jul 01, 2023
27 Resources
0 Stars
Curated
27 Resources
0 Stars
Curated
Utah FORGE 1-2551: Multi-Stage Fracturing System and Well Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores Workshop Presentation and Report
Included here are a presentation recording, slides, and report on the Multi-Stage Fracturing System and Well Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores project by Colorado School of Mines, presented by Dr. William W. Fleckenstei...
Fleckenstein, W. et al Colorado School of Mines
Sep 08, 2023
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Utah FORGE 5-2428: Coupled Investigation of Fracture Permeability Impact on Reservoir Stress and Seismic Slip 2024 Annual Workshop Presentation
This is a presentation on the Coupled Investigation of Fracture Permeability Impact on Reservoir Stress and Seismic Slip Behavior by Lawrence Livermore National Laboratory, presented by Kayla Kroll. This presentation addresses testing and modelling related to the dependency of EG...
Kroll, K. et al Energy and Geoscience Institute at the University of Utah
Aug 27, 2024
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE 1-2551: Development of a Multi-Stage Fracturing System and Wellbore Tractor 2024 Annual Workshop Presentation
This is a presentation on the Development of a Multi-Stage Fracturing System and Wellbore Tractor by Colorado School of Mines, presented by William Fleckenstein. This video describes (1) the development and use of a low-cost and rapid multistage fracture stimulation technology wit...
Fleckenstein, W. Energy and Geoscience Institute at the University of Utah
Jan 13, 1970
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE: Mineral Mountains West Fault System Report
This archive contains a report on the Mineral Mountains West fault system as part of phase 2C and the evidence for the northern terminus of this structure. Geologic field mapping, reprocessing of 3D seismic reflection data, and soil gas surveys contributed to this effort.
Simmons, S. and Miller, J. Energy and Geoscience Institute at the University of Utah
Jul 01, 2019
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE 4-2492: Design and Implementation of Innovative Stimulation Treatments to Maximize Energy Recovery Workshop Presentation
This is a presentation on the Design and Implementation of Innovative Stimulation Treatments to Maximize Energy Recovery Efficiency at the Utah FORGE Site project by The University of Texas at Austin, presented by Professor Mukul M. Sharma. The project's objectives were to place f...
Sharma, M. The University of Texas at Austin
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution
Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...
Lockner, D. et al United States Geological Survey
Apr 03, 2023
2 Resources
0 Stars
Curated
2 Resources
0 Stars
Curated
Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment
Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...
Roseboom, M. et al Pennsylvania State University
Nov 07, 2023
6 Resources
0 Stars
Curated
6 Resources
0 Stars
Curated
Utah FORGE: Fluid Injection Induced Shearing Experiments on Fractured Granitoid at Elevated Temperatures
This repository contains experimental data from a series of fluid injection-induced shearing tests conducted on Utah FORGE granitoid. The experiments were performed using an aluminum triaxial pressure vessel (TEMCO) apparatus at Pennsylvania State University. The primary aim was t...
Elsworth, D. et al Pennsylvania State University
Aug 12, 2024
16 Resources
0 Stars
Curated
16 Resources
0 Stars
Curated
Utah FORGE 5-2557: Role of Fluid and Temperature in Fracture Mechanics and Couples THMC Processes for Enhanced Geothermal Systems 2024 Annual Workshop Presentation
This is a presentation on the Role of Fluid and Temperature in Fracture Mechanics and Couples THMC Processes for Enhanced Geothermal Systems by Purdue University, presented by Laura Pyrak-Nolte. This video slide presentation describes the development and validation of a macroscopi...
Pyrak-Nolte, L. Energy and Geoscience Institute at the University of Utah
Aug 13, 2024
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE: Core Material Friction Experiments
The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
Marone, C. et al Pennsylvania State University
Mar 15, 2023
7 Resources
0 Stars
Curated
7 Resources
0 Stars
Curated
Utah FORGE: Well 16A(78)-32/Well16B(78)-32 Circulation Test Data
This dataset encompasses the collected data and associated reports from the low-rate injection circulation test conducted on wells 16A(78)-32 and 16B(78)-32 in July 2023 at Utah FORGE. It includes comprehensive raw circulation data, captured by Pason and Schlumberger (SLB). The da...
Mclennan, J. and Xing, P. Energy and Geoscience Institute at the University of Utah
Jul 19, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Slide-Hold-Slide Experiments on Westerly Granite at Temperatures up to 250 Degrees C
Laboratory slide-hold-slide tests were conducted in a conventional triaxial deformation configuration on 1-inch diameter cylindrical cores of Westerly granite bisected by a sawcut oriented at 30 degrees from vertical. Tests were conducted at a constant confining pressure of 30 MPa...
Jeppson, T. et al United States Geological Survey
Oct 10, 2023
2 Resources
0 Stars
Curated
2 Resources
0 Stars
Curated
Utah FORGE: Well 16B(78)-32 Drilling Data
This drilling data for Utah FORGE well 16B(78)-32 include a well survey, core summary, mud and mud temperature logs, daily reports of the drilling process, and additional data from the Pason oil and gas company. Well 16B(78)-32 serves as the production well for reservoir creation...
McLennan, J. et al Energy and Geoscience Institute at the University of Utah
Jul 03, 2023
9 Resources
0 Stars
Publicly accessible
9 Resources
0 Stars
Publicly accessible
Utah FORGE 5-2557: Fluid and Temperature in Fracture Mechanics and Coupled THMC Processes Workshop Presentation
This is a presentation on the Role of Fluid and Temperature in Fracture Mechanics and Coupled Thermo-Hydro-Mechanical-Chemical (THMC) Processes for Enhanced Geothermal Systems project by Purdue University, presented by Distinguished Professor of Physics & Astronomy, Laura J. Pyrak...
Pyrak-Nolte, L. Purdue University
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Heat Flow Contours and Well Data
This submission contains a shapefile of heat flow contour lines around the FORGE site located in Milford, Utah. The model was interpolated from data points in the Milford_wells shapefile. This heat flow model was interpolated from 66 data points using the kriging method in Geostat...
Moore, J. Energy and Geoscience Institute at the University of Utah
Mar 09, 2016
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Development of Multi-Stage Fracturing System and Wellbore Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores
This paper discusses the progress on a project funded by the DOE Utah FORGE (Frontier Observatory for Research in Geothermal Energy) for the development of a subsurface heat exchanger for Enhanced Geothermal Systems (EGS) using unique casing sleeves cemented in place and are used ...
Fleckenstein, W. et al Colorado School of Mines
Oct 05, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE 4-2541: Optimization and Validation of a Plug-and-Perf Stimulation Treatment Design Workshop Presentation
This is a presentation on the Optimization and Validation of a Plug-and-Perf Stimulation Treatment Design at Utah FORGE project by Fervo Energy, presented by Sireesh Dadi. The project's objective was to develop a multistage hydraulic stimulation approach designed specifically to t...
Dadi, S. and Norbeck, J. Fervo Energy
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Injection Test Data
This submission contains pressure and flow time series data from the reservoir testing of Well 58-32. These activities were part of the Utah FORGE Phase 2B site suitability confirmatory testing.
Podgorney, R. and McLennan, J. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Wells 16A(78)-32 and 16B(78)-32 Extended Circulation Test Data August and September 2024
The dataset includes data collected during an extended circulation test conducted at the Utah FORGE site between August 8 and September 5, 2024. It provides uncorrected, raw digital data from the test, along with calibration information and a final report detailing the test proced...
McLennan, J. et al Energy and Geoscience Institute at the University of Utah
Oct 11, 2024
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Utah FORGE: Well 16A(78)-32 Stimulation Tracer Test Results
This archive contains data from the tracer test performed during the Utah FORGE well 16A(78)-32 stimulation. This includes:
1. the raw data file from Pason in the csv format;
2. a one-page Word document from Pason that explains the headers and units used in their data file;
3. an...
Rose, P. and Barker, B. Energy and Geoscience Institute at the University of Utah
Sep 16, 2022
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 16A(78)-32 and 16B(78)-32 Stimulation Production Logging Tests
These are production logging tests (PLT) results from Halliburton collected during the nine hour circulation test performed at Utah FORGE on April 27th, 2024. The circulation test involved injecting into well 16A(78)-32 and producing out of well 16B(78)-32) and was carried out af...
Haroun, F. Energy and Geoscience Institute at the University of Utah
Apr 27, 2024
4 Resources
1 Stars
Publicly accessible
4 Resources
1 Stars
Publicly accessible
Utah FORGE 1-2409: Zonal Isolation Solution for Geothermal Wells Workshop Presentation
This is a presentation on the Zonal Isolation Solution for Geothermal Wells project by PetroQuip Energy Services, presented by VP of operations Robert Coon. The project's objective was to design and develop a multi-stage system for zonally isolating fluids inside and outside of g...
Coon, R. et al PetroQuip Energy Services
Sep 08, 2023
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible