Search GDR Data

Utah FORGE: Temperature-Dependent Fracture Seismicity from Fluid Injection Experiments

This dataset contains experimental data from fluid injection experiments conducted to investigate the influence of temperature on fracture seismicity. The experiments were performed on granite samples from Utah FORGE. The samples were prepared with a 30-degree inclined fracture an...

Wang, J. et al Pennsylvania State University

Feb 29, 2024
4 Resources
0 Stars
Curated

Utah FORGE 2439: Report on Minifrac Tests for Stress Characterization

This report describes minifrac tests conducted in the 16B(78)-32 well at the Utah FORGE site to characterize subsurface stresses, including the magnitude and orientation of the minimum and maximum horizontal stresses and the magnitude of the vertical stress. A minifrac test was co...

Kelley, M. et al Battelle Memorial Institute

Feb 22, 2024
1 Resources
0 Stars
Curated

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...

Marone, C. et al Pennsylvania State University

Mar 15, 2023
7 Resources
0 Stars
Curated

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...

Yu, J. et al Pennsylvania State University

Jul 01, 2023
27 Resources
0 Stars
Curated

Utah FORGE 2439: Well 16B(78)-32 Field-Test Data from Mini-Frac Tests

This submittal includes the field-test data collected during stress tests conducted in the Utah FORGE 16B(78)-32 wellbore to measure/characterize the stresses in the geothermal reservoir. The type of stress test performed is referred to as a mini-frac test or a micro-frac test. Th...

Kelley, M. et al Battelle Memorial Institute

Jul 02, 2023
3 Resources
0 Stars
Curated

Utah FORGE: Seismic and Other Shapefiles from the Roosevelt Hot Springs Area

Three shapefiles in this submission show the position of proposed seismic line surveys. The mid-crustal velocity anomaly file shows the extent of an anomalously low P-wave velocity zone in the subsurface. Two other files show the extent of known hydrothermal systems in the Rooseve...

Moore, J. Energy and Geoscience Institute at the University of Utah

Mar 22, 2016
7 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Stimulation Conference Paper and Data

The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...

Best, S. Energy and Geoscience Institute at the University of Utah

Apr 24, 2019
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Fluid Injection Induced Shearing Experiments on Fractured Granitoid at Elevated Temperatures

This repository contains experimental data from a series of fluid injection-induced shearing tests conducted on Utah FORGE granitoid. The experiments were performed using an aluminum triaxial pressure vessel (TEMCO) apparatus at Pennsylvania State University. The primary aim was t...

Elsworth, D. et al Pennsylvania State University

Aug 12, 2024
16 Resources
0 Stars
Curated

Utah FORGE: Wells Updated Temperature and Pressure Logs (June 2021)

This dataset includes updated temperature and pressure logs for Utah FORGE wells 56-32, 78-32, and 58-32. This data was acquired in June 2021.

Stout, F. Di Drill Survey Services

Jun 29, 2021
4 Resources
0 Stars
Curated

Utah FORGE: Well 16B(78)-32 Pressure-Temperature Logs March April 2024

This dataset consists of Baker Hughes Pressure-Temperature gauge readings on fiber optics in Utah FORGE Well 16B(78)-32. This gauge is at a measured depth of 7,056.67 feet. The true vertical depth can be determined from the well survey data, which is linked below. The data consis...

McLennan, J. and Hughes, B. Energy and Geoscience Institute at the University of Utah

Apr 20, 2024
2 Resources
0 Stars
Curated

Utah FORGE: Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics

Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and ...

Eijsink, A. and Elsworth, D. Pennsylvania State University

Jul 08, 2022
2 Resources
0 Stars
Curated

Utah FORGE: Milford Deep Test Well 58-32 (MU-ESW1) Pressure and Temperature Logs

This archive consists of a pdf graphic log and a LAS text file representing the results of the pressure and temperature logs measured on Nov. 8th, 2018 from the Utah FORGE deep test well 58-32 (MU-ESW1). The logs were taken by DI Drill Survey Services.

Moore, J. Energy and Geoscience Institute at the University of Utah

Nov 08, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Pressure Temperature Logs from Blundell Well 71-10, Beaver County

This archive contains an Excel spreadsheet with pressure and temperature logs from PacifiCorp well 71-10. This well is in the Blundell Power Plant geothermal well field near Roosevelt Hot Springs, Beaver County, Utah. The spreadsheet also contains UTM coordinates for the location ...

Foster, K. Energy and Geoscience Institute at the University of Utah

Oct 08, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2615: Well 58-32 and 78-32 Poroelastic Properties

Lab data on permeability, grain bulk modulus, drained bulk modulus, Skempton's pore pressure coefficient, and Biot's effective stress coefficient for Utah Forge Well 58-32 and Well 78-32. Work done as part of project number 5-2615 by the University of Oklahoma.

Ghassemi, A. and Zhou, X. University of Oklahoma

Oct 31, 2022
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Wells 16A(78)-32 and 16B(78)-32 Stimulation Pressure and Circulation Data April, 2024

This dataset consists of all of the pressure pumping data for Utah FORGE Well16A78-32 fracturing stages, Well 16B78-32 fracturing stages, and a 9-hour circulation test which took place after all of the frac plugs were drilled out. Fracturing in the wells took place in stages from ...

England, K. Energy and Geoscience Institute at the University of Utah

Jun 03, 2024
4 Resources
0 Stars
Curated

Utah FORGE: Well 16A(78)-32/Well16B(78)-32 Circulation Test Data

This dataset encompasses the collected data and associated reports from the low-rate injection circulation test conducted on wells 16A(78)-32 and 16B(78)-32 in July 2023 at Utah FORGE. It includes comprehensive raw circulation data, captured by Pason and Schlumberger (SLB). The da...

Mclennan, J. and Xing, P. Energy and Geoscience Institute at the University of Utah

Jul 19, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 Stage 1 Pressure Falloff Analysis

This is an analysis of the pressure falloff in stage 1 fracture stimulation of FORGE well 16A(78)-32. The objective of this research is to understand the information content of the well stimulation data of FORGE Well 16A(78)-32. The Stage 1 step-rate test, a variant of the classic...

Kazemi, H. et al Colorado School of Mines

Aug 04, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 a...

Jeppson, T. and Lockner, D. United States Geological Survey

Feb 24, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment

Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...

Roseboom, M. et al Pennsylvania State University

Nov 07, 2023
6 Resources
0 Stars
Curated

Utah FORGE: Well 58-32 Stimulation Data

Pressure, temperature, and flow data from open-hole, upper perforation, and lower perforation well stimulations gathered from various tools collected at well 58-32 during phase 2C.

Best, S. Geothermal Resource Group

Apr 20, 2019
16 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 58-32 Injection Test Data

This submission contains pressure and flow time series data from the reservoir testing of Well 58-32. These activities were part of the Utah FORGE Phase 2B site suitability confirmatory testing.

Podgorney, R. and McLennan, J. Idaho National Laboratory

Dec 07, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Pump and Probe Test on a Mated Fracture Westerly Granite Sample

This dataset contains results from a pump and probe experiment conducted on a mated fracture Westerly Granite sample with a diameter of 1 inch and a height of 2 7/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-line...

Klinghammer, H. et al Pennsylvania State University

May 19, 2024
4 Resources
0 Stars
Curated

Utah FORGE: Neubrex Well 16B(78)-32 Stimulation Fiber Optic Monitoring Reports April and May, 2024

These reports contain information on the distributed temperature sensing (DTS), distributed strain sensing (DSS), and pressure monitoring during the stimulation of Well 16(B)78-32 at Utah FORGE, in April and May 2024. Reports include information on data collection and calibrations...

Jurick, D. and Guzik, D. Neubrex Energy Services (US), LLC

Apr 30, 2024
3 Resources
0 Stars
Curated

Utah FORGE: Data for 3-D Model Development Lithology, Temperature, Pressure, and Stress

This submission comprises two downloadable .zip archives. Each archive contains spreadsheets with 3-D data and a .txt document describing the data. The Mesh Files .zip download contains data regarding the lithologic contacts of the granitoid and overlying sedimentary basin fill. T...

Podgorney, R. Idaho National Laboratory

Mar 17, 2020
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Phase Native State FALCON Model Files

The submission includes FALCON input file and mesh for the an initial pressure-temperature simulation, and a second set for pressure-temperature-displacement simulation. All simulations are steady state. Data and input for the FORGE Phase 2 native state model were compiled from hi...