Search GDR Data
Showing results 1 - 25 of 163.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
FY13 annual report describing the calculations and results associated with the data and dissolution rate contained in "Chlorite Kinetic Dissolution Data and Rate" (linked below).
Chemical reactions pose an important but poorly understood threat to EGS long-term success because of their impact on fracture permeability. This report summarizes the dissolution rate equations for layered silicates where data were lacking for geothermal systems. Here we report ...
We have calculated a chlorite dissolution rate equation at far from equilibrium conditions by combining new data (20 experiments at high temperature) with previously published data Smith et al. 2013 and Lowson et al. 2007. All rate data (from the 127 experiments) are tabulated in...
This is data collected during tests of Kinetics of Chlorite Dissolution at Elevated Temperatures and CO2 Conditions as described in the paper included in the linked GDR submission. The spreadsheet provides measured chlorite rate data from 100 to 300 degrees C at elevated CO2. Spre...
The objective of this suite of experiments was to develop a useful kinetic dissolution expression for illite applicable over an expanded range of solution pH and temperature conditions representative of subsurface conditions in natural and/or engineered geothermal reservoirs. Usi...
Methods and results of the Kinetics of Chlorite Dissolution at Elevated Temperatures and CO2 Conditions are described and discussed in the paper. Data from this experiment is included as a downloadable .xlsx spreadsheet in the linked GDR submission.
Chlorite dissolution kinetics w...
Spreadsheet containing chlorite, illite, and biotite rate data and rate equations that can be used in reactive transport simulations. Submission includes a report on the development of the rate laws.
Compressibility values were obtained in a range of pressures at 250degC by employing a fixed volume view cell completely filled with PAA aqueous solution and injecting CO2 at constant flow rate (0.3mL/min). Pressure increase as a function of supercritical CO2 (scCO2) mass fraction...
Numerical simulations have shown that the use of supercritical CO2 instead of water as a heat transfer fluid yields significantly greater heat extraction rates for geothermal energy. If this technology is implemented successfully, it could increase geothermal energy production and...
A set of triaxial tests with sandstone, limestone, and granite samples was conducted to measure fluid chemistry before, during, and after rock fracture. The dataset here includes: 1) five triaxial test data files (xlxs), 2) one file containing the measured test tube volumes for th...
There is an ongoing effort at Oak Ridge National Laboratory to develop a unique experimental capability for investigating flow through porous and fractured media using neutron imaging techniques. This capability is expected to support numerous areas of investigation associated wit...
This dataset contains geochemical analyses of produced fluids from the Utah FORGE site, specifically from wells 16A(78)-32, 16B(78)-32, and 58-32, collected during various stimulation, flowback, and circulation tests conducted between 2022 and 2024. The data contains element conce...
Included are experimental data recorded from shear experiments that explore the effects of pore pressure heterogeneity on microseismic character and fault slip timing resulting from shear reactivation of laboratory faults. Raw mechanical and acoustic data from 15 experiments are i...
This submission contains slow strain rates summed to radians over 30 second intervals [rad/s] derived from horizontal distributed acoustic sensing measurements (DASH) of Brady geothermal field during PoroTomo deployment (2016-Mar-14 to 2016-Mar-26). There is one file correspondin...
Newberry Volcano in Central Oregon is the site of a Department of Energy funded Enhanced Geothermal System (EGS) Demonstration Project. Stimulation and production of an EGS is a strong perturbation to the physical and chemical environment, giving rise to coupled Thermal-Hydrologic...
This dataset includes Rayleigh Frequency Shift (RFS) Distributed Strain Sensing (DSS) cumulative strain change and change rate data. The data was acquired during the stimulation of Utah FORGE Well 16A(78)-32 in April 2024 via fiber installed in Well 16B(78)-32. The fiber optic da...
Global Positioning System (GPS) time series from the National Science Foundation (NSF) Earthscope's Plate Boundary Observatory (PBO) and Central Washington University's Pacific Northwest Geodetic Array (PANGA). GPS station velocities were used to infer strain rates using the "spli...
Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...
This submission contains curated injection parameter datasets from the 2022 and 2024 stimulation experiments conducted at the Utah FORGE site, along with the report documenting the data processing workflow. The datasets were developed as part of Project 6-3712: Probabilistic Estim...
This dataset encompasses the collected data and associated reports from the low-rate injection circulation test conducted on wells 16A(78)-32 and 16B(78)-32 in July 2023 at Utah FORGE. It includes comprehensive raw circulation data, captured by Pason and Schlumberger (SLB). The da...
Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite.
All expe...
This dataset contains strain change rate versus depth data acquired using a Rayleigh frequency shift (RFS) distributed strain sensing (DSS) system during hydraulic stimulation of well 16A(78)-32 at the Utah FORGE site in April 2024. The data were collected from an optical fiber in...
Drilling results from the microhole project at the Sandia High Operating Temperature test facility. The project is seeking to help reduce the cost of exploration and monitoring of geothermal wells and formations by drilling smaller holes. The tests were part of a control algorith...
Measurements of particle extraction efficiency under various flow rate and magnetic power conditions
This dataset contains results from five laboratory shear experiments on gneiss and granitoid samples from the Utah FORGE site, conducted at Penn State University. The experiments investigate links between fault surface roughness, frictional behavior, permeability, and P-wave acous...
Google Map