Search GDR Data
Showing results 1 - 25 of 173.
Show
results per page.
Order by:
Available Now:
Technologies
Featured Projects
Topics
Data Type
Newberry EGS Demonstration: Initial Project Report and Induced Seismicity Mitigation Plan, 2011
This is the first project report and induced seismicity mitigation plan for the Newberry Enhanced Geothermal Systems (EGS) Demonstration project. The primary objectives of this first phase were to obtain necessary permits and comply with all regulations, including NEPA, communica...
Cladouhos, T. et al AltaRock Energy Inc
May 05, 2024
4 Resources
0 Stars
Curated
4 Resources
0 Stars
Curated
Utah FORGE: Borehole Sensors and Well Trajectories (April 2022)
This link leads to a webpage with spreadsheets containing seismic borehole sensor locations and well trajectories for wells 56-32, 58-32, 78-32, 78B-32. Each of the files at the provided link include meta data on relevant information.
Pankow, K. University of Utah Seismograph Stations
Dec 23, 2022
1 Resources
0 Stars
Curated
1 Resources
0 Stars
Curated
Raw Pressure Data from Boise Hydrogeophysical Research Site (BHRS)
Pressure data from a phreatic aquifer was collected in the summer of 2013 during Multi-frequency Oscillatory Hydraulic Tomography pumping tests. All tests were performed at the Boise Hydrogeophysical Research Site. The data will be inverted using a fast steady-periodic adjoint-bas...
Lim, D. University of Wisconsin
Jul 17, 2013
20 Resources
0 Stars
Publicly accessible
20 Resources
0 Stars
Publicly accessible
Analyzed Boise Data for Oscillatory Hydraulic Tomography
Data here has been "pre-processed" and "analyzed" from the raw data submitted to the GDR previously (raw data files found at http://gdr.openei.org/submissions/479. doi:10.15121/1176944 after 30 September 2017). First, we submit .mat files which are the "pre-processed" data (must h...
Lim, D. University of Wisconsin
Jul 01, 2015
8 Resources
0 Stars
Publicly accessible
8 Resources
0 Stars
Publicly accessible
Utah FORGE: Roosevelt Hot Springs Analytical Well-Based Temperature Model Data
This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corre...
Podgorney, R. and Allis, R. Idaho National Laboratory
Dec 07, 2018
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis
Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...
Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory
Mar 09, 2018
11 Resources
0 Stars
Publicly accessible
11 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Schlumberger FMI Logs DLIS and XML files
This zipped data set includes Schlumberger FMI logs DLIS and XML files from Utah FORGE deep well 58-32. These include runs 1 (2226-7550 ft) and 2 (7440-7550 ft). Run 3 (7390-7527ft) was acquired during phase 2C.
Nash, G. and Moore, J. Energy and Geoscience Institute at the University of Utah
Nov 17, 2017
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Hawaii Play Fairway Analysis: Groundwater Chemistry
Groundwater geochemistry data collected for the phase 2 of the Hawaii Play Fairway Analyses. These data are included in a Lautze et al. paper to Geothermics (in review).
Lautze, N. University of Hawaii
Mar 20, 2017
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 16A(78)-32 Stimulation DFN Fracture Plane Evaluation and Data
This dataset includes files used to fit planar fractures through the preliminary earthquake catalogs of the three stages of the April 2022 well 16A(78)-32 stimulation which is linked bellow. These planar features have been used to update the FORGE reference Discrete Fracture Netwo...
Finnila, A. WSP Golder
Oct 27, 2022
3 Resources
0 Stars
Curated
3 Resources
0 Stars
Curated
University of Illinois Campus Deep Direct-Use Feasibility Study Geological Characterization of the Mt. Simon Sandstone
These studies undertook detailed analyses of the Mt. Simon Sandstone in the Illinois Basin for geological storage and sequestration, and brine extraction.
Lin, Y. et al University of Illinois
Mar 30, 2018
5 Resources
0 Stars
Curated
5 Resources
0 Stars
Curated
Utah FORGE 3-2535: Numerical Modeling of Energized Steel-Casing Source for Imaging Stimulated Zone
This short report details and tests the workflow that will be used to simulate steel well casings in deviated production/extraction boreholes at at the Utah FORGE site. Boreholes will be electrically energized and will serve as data sources for future proposed electromagnetic bore...
Um, E. et al Lawrence Berkeley National Laboratory
Nov 15, 2022
4 Resources
0 Stars
Curated
4 Resources
0 Stars
Curated
Hawaii Play Fairway: Preliminary Core Box Photos, Lanai Island, Hawaii
Photos of core samples from Lanai Island. During the third phase of the Hawaii Play Fairway project, further exploration involved drilling a groundwater well in Lanai's Palawai Basin and performing more geophysical surveys. The project deepened an existing water well on Lanai. Dri...
Lautze, N. et al University of Hawaii
Jul 01, 2019
3 Resources
0 Stars
Publicly accessible
3 Resources
0 Stars
Publicly accessible
Utah FORGE 2439: Machine Learning for Well 16A(78)-32 Stress Predictions September 2023 Report
This task completion report documents the development and implementation of machine learning (ML) models for the prediction of in-situ vertical (Sv), minimum horizontal (SHmin) and maximum horizontal (SHmax) stresses in well 16A(78)-32. The detailed description of the experimental...
Mustafa, A. et al Battelle Memorial Institute
Sep 28, 2023
3 Resources
0 Stars
Curated
3 Resources
0 Stars
Curated
Utah FORGE 3-2535: Modeling Studies of Energized Steel-Casing Source EM Method for Detecting Stimulated Zone
Numerical modeling Studies for electromagnetic (EM) Data Acquisition Survey Design this milestone report describes the 3D modeling studies of energized steel-casing source electromagnetic method for detecting stimulated zone at the Utah FORGE Site. FORGE project 3-2535 is planning...
Um, E. et al Lawrence Berkeley National Laboratory
Feb 06, 2023
4 Resources
0 Stars
Curated
4 Resources
0 Stars
Curated
Subsurface Characterization and Machine Learning Predictions at Brady Hot Springs Results
Geothermal power plants typically show decreasing heat and power production rates over time. Mitigation strategies include optimizing the management of existing wells increasing or decreasing the fluid flow rates across the wells and drilling new wells at appropriate locations. Th...
Beckers, K. et al National Renewable Energy Laboratory
Oct 20, 2021
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Machine Learning to Identify Geologic Factors Associated with Production in Geothermal Fields: A Case-Study Using 3D Geologic Data from Brady Geothermal Field and NMFk
In this paper, we present an analysis using unsupervised machine learning (ML) to identify the key geologic factors that contribute to the geothermal production in Brady geothermal field. Brady is a hydrothermal system in northwestern Nevada that supports both electricity producti...
Siler, D. et al United States Geological Survey
Oct 01, 2021
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
Snake River Plain FORGE: Site Characterization Data
The site characterization data used to develop the conceptual geologic model for the Snake River Plain site in Idaho, as part of phase 1 of the Frontier Observatory for Research in Geothermal Energy (FORGE) initiative. This collection includes data on seismic events, groundwater,...
Moos, D. and Barton, C. Idaho National Laboratory
Apr 18, 2016
49 Resources
0 Stars
Curated
49 Resources
0 Stars
Curated
Utah FORGE 3-2535: Building a 3D Resistivity Model for Simulation and Survey Design of EM Measurements
The included report outlines the creation of three 3D resistivity models that will be used to determine the sensitivity of EM measurements for the hypothetical stimulated reservoir at FORGE as well as for EM survey design. FORGE project 3-2535 is planning on using a casing source ...
Alumbaugh, D. et al Lawrence Berkeley National Laboratory
Dec 01, 2022
5 Resources
0 Stars
Curated
5 Resources
0 Stars
Curated
Utah FORGE 3-2535: Compilation of Geodetic Data and Estimation of Associated Deformation
Report on possible geodetic signature of the 3 stimulations in April 2022 as well as a comparison with existing InSAR data gathered over the site before, during, and after the stimulation. In geothermal production it is important to understand the existing stress field and the cha...
Vasco, D. et al Lawrence Berkeley National Laboratory
Apr 29, 2022
4 Resources
0 Stars
Curated
4 Resources
0 Stars
Curated
Feasibility of a Deep Direct-Use Geothermal System at the University of Illinois Urbana-Champaign
Paper authored by Stumpf et al. for the 2018 Geothermal Resources Council Annual Meeting held in Reno, NV USA. Included with the paper is the Microsoft PowerPoint presentation made at the GRC meeting and data tables associated with some of the figures.
Stumpf, A. et al University of Illinois
Dec 31, 2018
6 Resources
0 Stars
Publicly accessible
6 Resources
0 Stars
Publicly accessible
USGS Geophysics, Heat Flow, and Slip and Dilation Tendency Data used in Applications of Machine Learning Techniques to Geothermal Play Fairway Analysis in the Great Basin Region, Nevada
This package contains USGS data contributions to the DOE-funded Nevada Geothermal Machine Learning Project, with the objective of developing a machine learning approach to identifying new geothermal systems in the Great Basin. This package contains three major data products (geoph...
DeAngelo, J. et al Nevada Bureau of Mines and Geology
Jun 01, 2021
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
Utah FORGE: Well 58-32 Stimulation Conference Paper and Data
The U.S. Department of Energy's (U.S. DOE) Frontier Observatory for Research in Geothermal Energy (FORGE) is a field laboratory that provides a unique opportunity to develop and test new technologies for characterizing, creating and sustaining Enhanced Geothermal Systems (EGS) in ...
Best, S. Energy and Geoscience Institute at the University of Utah
Apr 24, 2019
2 Resources
0 Stars
Publicly accessible
2 Resources
0 Stars
Publicly accessible
Utah FORGE: Southwestern Utah Magnetotelluric (MT) Data
This comprehensive magnetotellurics (MT) dataset, which covers southwestern Utah, integrates 600 sites from various surveys, including those from the Utah FORGE, SubTER, and Play Fairway projects, all of which are linked below. The core of this dataset is the use of a 3D finite el...
Wannamaker, P. and Marris, V. Energy and Geoscience Institute at the University of Utah
Jan 22, 2024
4 Resources
0 Stars
Publicly accessible
4 Resources
0 Stars
Publicly accessible
Utah FORGE: Temperature Gradient Database
This is a temperature gradient database for Utah, USA. It is located at the Utah Geological Survey. This contains data relevant to the Utah FORGE project.
Nash, G. Energy and Geoscience Institute at the University of Utah
Feb 01, 2004
1 Resources
0 Stars
Publicly accessible
1 Resources
0 Stars
Publicly accessible
University of Illinois Campus Deep Direct-Use Feasibility Study Geological Characterization of the St. Peter Sandstone
These studies undertook detailed analyses of the formations within the Cambro-Ordovician strata above the Mt. Simon Sandstone in the Illinois Basin, including the St. Peter Sandstone, for geological storage and mineral potential.
Lin, Y. et al University of Illinois
Mar 30, 2018
4 Resources
0 Stars
Curated
4 Resources
0 Stars
Curated