Search GDR Data

Seismic Analysis of Spatio-Temporal Fracture Generation During EGS Resource Development Deviatoric MT, Fracture Network, and Final Report

This submission contains 167 deviatoric moment tensor (MT) solutions for the seismicity observed two years prior and three years post start of injection activities at The Geysers Prati 32 EGS Demonstration. Also included is a statistical representation of the properties of 751 fra...

Gritto, R. et al Array Information Technology

Sep 01, 2018
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32 2022 Stimulation Microseismic Report

This is a Utah FORGE well 16A(78)-32 stimulation microseismic detection and event location report from Silixa LLC. The report covers the digital acoustic sensing (DAS) data acquisition and analysis used to study microseismic events during the April, 2022 stimulations at well 16A(7...

LLC, S. Energy and Geoscience Institute at the University of Utah

Sep 26, 2022
1 Resources
0 Stars
Publicly accessible

Devices Suitable for Sectional Isolation Along Both Cased and Open-hole Wellbores Materials Testing Report

The main goal of this project is to develop an annular isolation system capable to withstand geothermal downhole conditions and mitigate the problems experienced by conventional packers in FORGE wells. This materials testing report is based on thermoplastic and elastomeric materia...

Teodoriu, C. et al Welltec

Nov 08, 2022
2 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: Accelerometer orientations

Document describing the methodology used to determine the accelerometers' three-component orientations at the first EGS Collab testbed using Continuous Active-Source Seismic Monitoring (CASSM) data and hodogram analysis. Original submission: gdr.openei.org/submissions/1166

Hopp, C. et al Lawrence Berkeley National Laboratory

Aug 19, 2020
2 Resources
0 Stars
Publicly accessible

Using Fully Coupled Hydro-Geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure

This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimu...

Fu, P. et al Lawrence Livermore National Laboratory

Jan 31, 2012
2 Resources
0 Stars
Publicly accessible

Effective Elastic and Neutron Capture Cross Section Calculations Corresponding to Simulated Fluid Properties from CO2 Push-Pull Simulations

The submission contains a .xls files consisting of 10 excel sheets, which contain combined list of pressure, saturation, salinity, temperature profiles from the simulation of CO2 push-pull using Brady reservoir model and the corresponding effective compressional and shear velocity...

Chugunov, N. and Altundas, B. Lawrence Berkeley National Laboratory

Mar 07, 2018
1 Resources
0 Stars
Publicly accessible

Utah FORGE 3-2514: A Strain Sensing Array to Characterize Deformation at the FORGE Site Workshop Presentation

This is a presentation on the Strain Sensing Array to Characterize Deformation at the FORGE Site project by Clemson University, presented by Lawrence Murdoch. The project's objective was to evaluate the feasibility of measuring and interpreting tensor strain data to improve the pe...

Murdoch, L. et al Clemson University

Sep 08, 2023
1 Resources
0 Stars
Publicly accessible

GEISER Project The Geysers Seismic Broadband Data 2012 2013

This link points to the Northern California Earthquake Data Center (NCEDC) to access The Geysers seismic broadband data. The two available data sets consist of continuous waveform data recorded at The Geysers from July 2012 to July 2013 and a processed catalog with earthquake info...

Gritto, R. Array Information Technology

Oct 31, 2018
2 Resources
0 Stars
Publicly accessible

Utah FORGE: GeoThermOPTIMAL Video

This is a project description video by Dr. William W. Fleckenstein related to their "Development of Multi-Stage Fracturing System and Wellbore Tractor to Enable Zonal Isolation During Stimulation and EGS Operations in Horizontal Wellbores" R&D project at Utah FORGE which is linked...

Fleckenstein, W. Colorado School of Mines

Dec 12, 2022
2 Resources
0 Stars
Curated

EGS Collab Experiment 1: Continuous Active-Source Seismic Monitoring (CASSM) Data

The U.S. Department of Energy's Enhanced Geothermal System (EGS) Collab project aims to improve our understanding of hydraulic stimulations in crystalline rock for enhanced geothermal energy production through execution of intensely monitored meso-scale experiments. The first expe...

Schoenball, M. and Sprinkle, P. Lawrence Berkeley National Laboratory

Apr 25, 2018
6 Resources
1 Stars
Publicly accessible

Simulations of Brady's-Type Fault Undergoing CO2 Push-Pull: Pressure-Transient and Sensitivity Analysis

Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...

Jung, Y. and Doughty, C. Lawrence Berkeley National Laboratory

Mar 09, 2018
11 Resources
0 Stars
Publicly accessible

Investigation of Stimulation-Response Relationships for Complex Fracture Systems in Enhanced Geothermal Reservoirs

Hydraulic fracturing is currently the primary method for stimulating low-permeability geothermal reservoirs and creating Enhanced (or Engineered) Geothermal Systems (EGS) with improved permeability and heat production efficiency. Complex natural fracture systems usually exist in ...

Fu, P. et al Lawrence Livermore National Laboratory

Jan 01, 2011
2 Resources
0 Stars
Publicly accessible

Utah FORGE: GES Well 16A(78)-32 and Well 16B(78)-32 Stimulation Seismic Event Catalogs

This dataset contains seismic event catalogs from the hydraulic stimulation of wells 16A(78)-32 and 16B(78)-32 at the Utah FORGE site in April 2024. The data was collected by Geo Energy Suisse (GES) using a variety of seismic monitoring technologies, including 3-component (3C) geo...

Dyer, B. et al University of Utah Seismograph Stations

Apr 30, 2024
2 Resources
0 Stars
Curated

Utah FORGE: High-Resolution DAS Microseismic Data from Well 78-32

This regards a high-resolution DAS microseismic dataset produced by Silixa from Utah FORGE Phase 2C seismic monitoring well 78-32 during stimulation testing of well 58-32. It is a very large dataset and as such it is currently not directly available on GDR. However, it is availabl...

Martin, T. and Nash, G. Energy and Geoscience Institute at the University of Utah

Oct 20, 2019
5 Resources
0 Stars
Publicly accessible

Newberry EGS Demonstration: Initial Project Report and Induced Seismicity Mitigation Plan, 2011

This is the first project report and induced seismicity mitigation plan for the Newberry Enhanced Geothermal Systems (EGS) Demonstration project. The primary objectives of this first phase were to obtain necessary permits and comply with all regulations, including NEPA, communica...

Cladouhos, T. et al AltaRock Energy Inc

May 05, 2024
4 Resources
0 Stars
Curated

EGS Collab Experiment 1: Circulation Testing

These data and test descriptions comprise a chilled circulation test conducted at the 164' fracture in the EGS Collab Experiment 1 testbed on the 4850 ft level of the Sanford Underground Research Facility. Descriptions of the meta data, design drawings for the flow testing system,...

Knox, H. et al Lawrence Berkeley National Laboratory

Apr 01, 2019
11 Resources
0 Stars
Publicly accessible

Utah FORGE: Wells 16A(78)-32/16B(78)-32 Stimulation Program Report May 2024

This is the end of job report for the stimulation program run on wells 16A(78)-32 and 16B(78)-32 done during May 2024.

McClennan, J. Energy and Geoscience Institute at the University of Utah

Nov 19, 2024
1 Resources
0 Stars
Awaiting curation

Full Moment Tensor Inversion Software

The link points to a website at NCEDC to download the full moment tensors inversion software The moment tensor analysis conducted in the current project is based on the full moment tensor model described in Minson and Dreger (2008). The software including source, examples and tut...

Gritto, R. and Dreger, D. Array Information Technology

Oct 31, 2018
1 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...

Ingraham, M. et al Sandia National Laboratories

Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

Numerical Modeling for Hydraulic Fracture Prediction

Numerical modeling on fused silica cylindrical materials for predicting overpressures required to fracture an homogeneous pure (surrogate) material with known mechanical properties similar to igneous rock materials and later compare these values to experimental overpressures obtai...

Gupta, V. Pacific Northwest National Laboratory

Apr 26, 2016
1 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 2: Testbed Well Orientation Data

This dataset contains the north seeking gyro data for each of the 11 boreholes drilled at the Experiment 2 testbed on the 4100 foot level of the SURF (Sanford Underground Research Facility). Each gyro file is in individual folders for each well. A single folder called 'E2 All Well...

Schwering, P. and Neupane, H. Lawrence Berkeley National Laboratory

Jul 26, 2021
2 Resources
0 Stars
Publicly accessible

Devices Suitable for Sectional Isolation Along Both Cased and Open-hole Wellbores Large-scale Test Setup

The main goal of this project is to develop an annular isolation system capable to withstand geothermal downhole conditions and mitigate the problems experienced by conventional packers in FORGE wells. This large-scale set-up report is about the system that has been constructed to...

Teodoriu, C. et al Welltec

Jan 31, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE: 2023 Phase 3B Year 1 Annual Report

This report discusses the objectives, goals, accomplishments and results of Phase 3B Year 1 of the Utah FORGE project. The report includes infrastructure, seismic monitoring, modelling, external R&D, communications and outreach, data produced, lessons learned, conclusions, and pla...

Moore, J. et al Energy and Geoscience Institute at the University of Utah

Aug 09, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Distributed Acoustic Sensing Data 2022

This is a link to the website where Distributed Acoustic Sensing (DAS) seismic data, collected from wells 78-32 and 78B-32 during the Utah FORGE 2022 stimulation, is available for download. The data can be accessed at "Well 16A78-32 2022 Stimulation Seismicity Data" link in the su...

Pankow, K. University of Utah Seismograph Stations

Apr 29, 2022
1 Resources
0 Stars
Curated

Utah FORGE: Microseismic Events

This archive contains Excel spreadsheets containing microseismic events detected in the study area during Utah FORGE Phase 2C. The Readme file included that describes the meaning of the abbreviations used as field headers in the spreadsheets. Additionally, there is a .dat (text) f...

Rutledge, J. Energy and Geoscience Institute at the University of Utah

Jul 08, 2019
2 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 Next >>