Search GDR Data

Chemical Impact of Elevated CO2 on Geothermal Energy Production

Numerical simulations have shown that the use of supercritical CO2 instead of water as a heat transfer fluid yields significantly greater heat extraction rates for geothermal energy. If this technology is implemented successfully, it could increase geothermal energy production and...

Carroll, S. et al Lawrence Livermore National Laboratory

Jan 01, 2013
3 Resources
0 Stars
Publicly accessible

Utah FORGE: Slide-Hold-Slide Experiments on Gneiss at Increased Temperature

Included are data from triaxial, single-inclined-fracture friction experiments. The experiments were performed with slide-hold-slide protocol on Utah FORGE gneiss at increased temperature. With a ~10 MPa normal stress, temperatures vary between experiments from room temperature u...

Eijsink, A. and Elsworth, D. Pennsylvania State University

Jul 25, 2023
24 Resources
0 Stars
Publicly accessible

Technology Development and Field Trials of EGS Drilling Systems at Chocolate Mountain

Polycrystalline diamond compact (PDC) bits are routinely used in the oil and gas industry for drilling medium to hard rock but have not been adopted for geothermal drilling, largely due to past reliability issues and higher purchase costs. The Sandia Geothermal Research Departmen...

Knudsen, S. et al Sandia National Laboratories

Jan 01, 2012
3 Resources
0 Stars
Publicly accessible

Water Use in Enhanced Geothermal Systems (EGS): Geology of U.S. Stimulation Projects, Water Costs, and Alternative Water Use Policies

According to the Energy Information Administration (EIA) of the U.S. Department of Energy (DOE), geothermal energy generation in the United States is projected to more than triple by 2040 (EIA 2013). This addition, which translates to more than 5 GW of generation capacity, is anti...

Harto, C. et al Argonne National Laboratory

Dec 16, 2014
13 Resources
1 Stars
Publicly accessible

US Low-Temperature EGS Resource Potential Estimate

Shapefile of shallow, low-temperature EGS resources for the United States, and accompanying paper (submitted to GRC 2016) describing the methodology and analysis. These data are part of a very rough estimate created for use in the U.S. Department of Energy Geothermal Technology O...

Mullane, M. et al National Renewable Energy Laboratory

Jun 30, 2016
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Deep Wells Water and Gas Sampling with Analyses by ThermoChem (October, 2022)

This data includes a document that describes the effort to collect and analyze water and gas samples from deep Utah FORGE wells 16A(78)-32, 58-32, 56-32 and 78B-32 along with additional pdf files showing ThermoChem's analyses attached as an appendix.

Joness, C. Energy and Geoscience Institute at the University of Utah

Oct 26, 2022
2 Resources
0 Stars
Publicly accessible

Testing for Controlled Rapid Pressurization

Borehole W1 is a NQ core hole drilled at our test site in Socorro. The rock is rhyolite. Borehole W1 which was used to test gas-gas explosive mixtures is 55 feet deep with casing (pinkish in the drawing) set to 35 feet. The model is a representation of the borehole and the hol...

Knudsen, S. Sandia National Laboratories

Sep 03, 2014
1 Resources
0 Stars
Publicly accessible

Penn State Lab Testing Fluid-Rock Interaction in Geothermal Reservoirs

This project focused on assessment and discovery of fluid-rock interaction in geothermal reservoirs. We accomplished work in four main areas: 1) fracture formation and the relationship between fluid flow and shear failure, 2) assessment of fracture geometry and fluid permeability ...

Madara, B. et al Pennsylvania State University

Jan 01, 2018
5 Resources
0 Stars
Publicly accessible

Cape EGS: Gold 2-IB Mass Spectrometry and Mudlogs

1. Mudlogs Mudlogs provide lithological information based on the analysis of drill cuttings and observed drilling parameters. These logs allow for the identification of formation changes, rock types, and basic mineral composition. They offer a continuous lithostratigraphic record ...

Dadi, S. and Adams, T. Fervo Energy

Apr 30, 2025
4 Resources
0 Stars
Awaiting curation

Utah FORGE: Soil Helium R/RA Data

This is a Helium isotope R/RA values from the Utah FORGE area near Roosevelt Hot Springs.

Simmons, S. Energy and Geoscience Institute at the University of Utah

Mar 12, 2018
1 Resources
0 Stars
Publicly accessible

Sustainable Self-Propping Shear Zones in EGS: Chlorite, Illite, and Biotite Rates and Report

Spreadsheet containing chlorite, illite, and biotite rate data and rate equations that can be used in reactive transport simulations. Submission includes a report on the development of the rate laws.

Carroll, S. and Smith, M. Lawrence Livermore National Laboratory

Nov 06, 2015
2 Resources
0 Stars
Publicly accessible

Chlorite Dissolution Kinetics at Variable pH and Temperatures up to 275C

FY13 annual report describing the calculations and results associated with the data and dissolution rate contained in "Chlorite Kinetic Dissolution Data and Rate" (linked below).

Carroll, S. and Smith, M. Lawrence Livermore National Laboratory

Oct 01, 2013
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Mineral Mountains West Fault System Report

This archive contains a report on the Mineral Mountains West fault system as part of phase 2C and the evidence for the northern terminus of this structure. Geologic field mapping, reprocessing of 3D seismic reflection data, and soil gas surveys contributed to this effort.

Simmons, S. and Miller, J. Energy and Geoscience Institute at the University of Utah

Jul 01, 2019
1 Resources
0 Stars
Publicly accessible

Chlorite Dissolution Rates From 25 to 275 degrees and pH 3 to 10

We have calculated a chlorite dissolution rate equation at far from equilibrium conditions by combining new data (20 experiments at high temperature) with previously published data Smith et al. 2013 and Lowson et al. 2007. All rate data (from the 127 experiments) are tabulated in...

Lawrence Livermore National Laboratory

Sep 27, 2013
2 Resources
0 Stars
Publicly accessible

Chlorite, Biotite, Illite, Muscovite and Feldspar Dissolution Kinetics at Variable pH and Temperatures up to 280 deg C

Chemical reactions pose an important but poorly understood threat to EGS long-term success because of their impact on fracture permeability. This report summarizes the dissolution rate equations for layered silicates where data were lacking for geothermal systems. Here we report ...

Carroll, S. et al Lawrence Livermore National Laboratory

Feb 24, 2017
2 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Energy Demand Characterization and Surface Plant Modeling for West Virginia University

This dataset provides information gathered to determine end use load and assessment of existing district heating systems (DHS). It also provides Aspen simulation files used to model hybrid natural gas geothermal district heating and cooling (GDHC) system along with Exchange Design...

Garapati, N. West Virginia University

Jan 09, 2020
4 Resources
0 Stars
Publicly accessible

Utah FORGE: 16B(78)-32 RFS DSS Strain Change Rate vs. Depth During 16A(78)-32 Stimulation

This dataset contains strain change rate versus depth data acquired using a Rayleigh frequency shift (RFS) distributed strain sensing (DSS) system during hydraulic stimulation of well 16A(78)-32 at the Utah FORGE site in April 2024. The data were collected from an optical fiber in...

Jurick, D. et al Neubrex Energy Services (US), LLC

Mar 02, 2025
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Fiber Optic Cumulative Strain Change and Strain Change Rate Data From Well 16A Stimulation at Well 16B

This dataset includes Rayleigh Frequency Shift (RFS) Distributed Strain Sensing (DSS) cumulative strain change and change rate data. The data was acquired during the stimulation of Utah FORGE Well 16A(78)-32 in April 2024 via fiber installed in Well 16B(78)-32. The fiber optic da...

Khatara, S. et al Neubrex Energy Services (US), LLC

Nov 06, 2024
2 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Shear Reactivation Experimental Data for Fluid Injection-Rate Controls on Seismic Moment

Included are experimental data recorded from shear experiments that specifically explore the link between fluid-injection rate and seismic moment resulting from shear reactivation of laboratory faults. Raw mechanical data from three experiments are included alongside corresponding...

Roseboom, M. et al Pennsylvania State University

Nov 07, 2023
6 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16A(78)-32/Well16B(78)-32 Circulation Test Data

This dataset encompasses the collected data and associated reports from the low-rate injection circulation test conducted on wells 16A(78)-32 and 16B(78)-32 in July 2023 at Utah FORGE. It includes comprehensive raw circulation data, captured by Pason and Schlumberger (SLB). The da...

Mclennan, J. and Xing, P. Energy and Geoscience Institute at the University of Utah

Jul 19, 2023
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All expe...

Yu, J. et al Pennsylvania State University

Jul 01, 2023
27 Resources
0 Stars
Publicly accessible

Utah FORGE: EGS Reservoir Produced Fluids Geochemistry 2022-2024

This dataset contains geochemical analyses of produced fluids from the Utah FORGE site, specifically from wells 16A(78)-32, 16B(78)-32, and 58-32, collected during various stimulation, flowback, and circulation tests conducted between 2022 and 2024. The data contains element conce...

Simmons, S. et al Energy and Geoscience Institute at the University of Utah

Feb 26, 2025
1 Resources
0 Stars
Publicly accessible

Brady's Geothermal Field Analysis of Pressure Data

*This submission provides corrections to GDR Submissions 844 and 845* Poroelastic Tomography (PoroTomo) by Adjoint Inverse Modeling of Data from Hydrology. The 3 *csv files containing pressure data are the corrected versions of the pressure dataset found in Submission 844. The ...

Lim, D. University of Wisconsin

Mar 17, 2017
6 Resources
0 Stars
Publicly accessible

EGS Collab Experiment 1: SIMFIP Notch-164 GRL Paper

Characterizing the stimulation mode of a fracture is critical to assess the hydraulic efficiency and the seismic risk related to deep fluid manipulations. We have monitored the three-dimensional displacements of a fluid-driven fracture during water injections in a borehole at ~1.5...

Guglielmi, Y. Lawrence Berkeley National Laboratory

Sep 24, 2020
9 Resources
0 Stars
Publicly accessible

Utah FORGE: Well 16B(78)-32 DTS, RFS DSS Strain, and Absolute Strain Circulation Test Fiber Optic Data August 2024

This dataset contains processed fiber optic measurements collected during the extended cross-well circulation test at the Utah FORGE site in August 2024. The data was acquired from the 16B(78)-32 well using distributed fiber optic sensing (DFOS) technology, including distributed t...