Search GDR Data
Showing results 1 - 25 of 290.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
Pushing the boundaries with geothermal tool development can often necessitate exceeding manufacturer specifications for temperature and pressure of individual circuit components. Detailed here are the efforts surrounding geothermal temperature characterization of commercially avai...
These data detail results from preliminary pH and reference electrode tests. The intention of this experiment is to test a novel High Temperature Chemical Sensing Tool for Distributed Mapping of Fracture Flow in EGS. 3 reference stability, a commercial reference, commercial stabil...
The CIRES remote sensing unit of the University of Colorado was commissioned by Flint Geothermal LLC to identify areas of warm ground that could signify the thermal signature of "blind" geothermal systems. Using ASTER and LANDSAT data along with other characteristics considered fa...
Pressure data recorded using PANEX pressure gauges at the bottom of wells CFU31-F2 and CFU31-F3.
Fabricated SiC diodes are tested in the temperature range of 300 degrees C to 600 degrees C.
The data set shows performance of economical calcium phosphate cement (Fondu) blended with fly ash, class F (FAF) in carbon steel corrosion protection tests (corrosion rate, corrosion current and potential), bond and matrix strength, as well as matrix strength recovery after impos...
This geodatabase was built to cover several geothermal targets developed by Flint Geothermal in 2012 during a search for high-temperature systems that could be exploited for electric power development. Several of the thermal springs and wells in the Routt Hot Spring and Steamboat ...
This layer contains transmission network of Colorado as released by Xcel Energy.
This geodatabase was built to cover several geothermal targets developed by Flint Geothermal in 2012 during a search for high-temperature systems that could be exploited for electric power development. Several of the thermal springs at Wagon Wheel Gap have geochemistry and geother...
This layer contains favorable geochemistry for high-temperature geothermal systems, as interpreted by Richard "Rick" Zehner. The data is compiled from the data obtained from the USGS. The original data set combines 15,622 samples collected in the State of Colorado from several sou...
This layer contains the regional faults of Colorado. The geodatabase includes show faults throughout Colorado and can be accessed with a GIS software.
The aim of this study is to understand how commercially available elastomers perform under geothermal well-like conditions and make recommendations to the community based on these results. This poster highlights the mechanical performance of several elastomers (including EPDM, Vit...
This geodatabase was built to cover several geothermal targets developed by Flint Geothermal in 2012 during a search for high-temperature systems that could be exploited for electric power development. Several of the thermal springs have geochemistry and geothermometry values indi...
This report outlines the approach and methodology of the utilization of thermal satellite imagery to find areas of warm ground that might indicate heat flow from a buried geothermal system. The satellite platforms, modeling equations and corrections to the data are discussed. Some...
This layer contains the weakened basement rocks. Isostatic gravity was utilized to identify structural basin areas, characterized by gravity low values reflecting weakened basement rocks. Together interpreted regional fault zones and basin outlines define geothermal "exploration f...
This submission includes three files from two sources. One file is derived from USGS data and includes a series of manipulations to evaluate only shallow wells with high estimated geothermal gradients. Two other files are springs and wells with discharge temperatures above 30 deg...
This layer traces apparent topographic and air-photo lineaments in the area around Pagosa springs in Archuleta County, Colorado. It was made in order to identify possible fault and fracture systems that might be conduits for geothermal fluids.
Geothermal fluids commonly utilize fa...
This layer contains the areas identified as areas of anomalous surface temperature from ASTER satellite imagery. The temperature is calculated using the Emissivity Normalization Algorithm that separate temperature from emissivity. Areas that had temperature greater than 2o, and ar...
Structural orientations (fractures, joints, faults, lineaments, bedding orientations, etc.) were collected with a standard Brunton compass during routine field examinations of geothermal phenomena in Colorado. Often multiple orientations were taken from one outcrop. Care was taken...
Penrose Well Temperatures
Geothermal waters have been encountered in several wells near Penrose in Fremont County, Colorado. Most of the wells were drilled for oil and gas exploration and, in a few cases, production.
This ESRI point shapefile utilizes data from 95 wells in and a...
This layer contains the areas identified as targets of potential geothermal activity. The Criteria used to identify the target areas include: hot/warm surface exposures modeled from ASTER/Landsat satellite imagery and geological characteristics, alteration mineral commonly associa...
This "Weakly Anomalous to Anomalous Surface Temperature" dataset differs from the "Anomalous Surface Temperature" dataset for this county (another remotely sensed CIRES product) by showing areas of modeled temperatures between 1o and 2o above the mean, as opposed to the greater th...
Modeled Bouger-Corrected Gravity data was extracted from the Pan American Center for Earth and Environmental Studies Gravity Database of the U.S. at http://irpsrvgis08.utep.edu/viewers/Flex/GravityMagnetic/GravityMagnetic_CyberShare/ on 2/29/2012. The downloaded text file was open...
Subsurface geothermal activity has a thermal expression that can be observed at the surface. Such spatial temperature gradients are within the radiometric resolution that is characteristic of a wide range of satellites that carry thermal sensors. For this effort, CIRES (part of ...
The data files below summarize the results from various experiments testing properties of high-temperature self-healing inorganic cement composites. These properties include cement-carbon steel bond strength, Young's modulus recovery, matrix recovery strength, and compressive stre...
Google Map