Search GDR Data
Showing results 1 - 24 of 24.
Show
results per page.
Order by:
Available Now:
Topic
Technologies
Demonstration Sites
Data Type
This entry contains raw data files from experiments performed on the Vulcan beamline at the Spallation Neutron Source at Oak Ridge National Laboratory using a pressure cell. Cylindrical granite and marble samples were subjected to confining pressures of either 0 psi or approximate...
The steel pipe experiment conducted in the lab was using 6 meter low-carbon steel pipe. We tested it with both dry and in-water condition. In the dry experimental setup, a coaxial cable acting as a return path in the air.
The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...
This dataset contains results from five laboratory shear experiments on gneiss and granitoid samples from the Utah FORGE site, conducted at Penn State University. The experiments investigate links between fault surface roughness, frictional behavior, permeability, and P-wave acous...
The coaxial-cable experiment conducted in the lab was with 80 m coaxial cable( RG-85). This experiment compares the TDR response between damaged and undamaged cable. For the damaged cable, the damaged section is in the middle (40 m). The amplitude of the data is mV with time (us).
These data and test descriptions are from a set of primarily tensile hydraulic-fracture stimulations in wells E2-TC and E2-TU and a subsequent chilled water circulation test conducted by injecting in well E2-TU on the 4100 level of the Sandford Underground Research Facility (SURF)...
The EGS Collab Experiment took place at the Sanford Underground Research Facility at the Homestake gold mine in Lead, SD, USA. Distributed fiber optic sensing temperature data is included in this dataset for this experiment.
A single loop of custom fiber package was grouted into ...
The U.S. Department of Energy's Enhanced Geothermal System (EGS) Collab project aims to improve our understanding of hydraulic stimulations in crystalline rock for enhanced geothermal energy production through execution of intensely monitored meso-scale experiments. The first expe...
This dataset contains results from a pump and probe experiment conducted on an intact Westerly Granite sample with a diameter of 1 inch and a height of 1 3/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-linear acou...
This dataset contains results from a pump and probe experiment conducted on a mated fracture Westerly Granite sample with a diameter of 1 inch and a height of 2 7/8 inches. The experiment was performed within an aluminum triaxial pressure vessel (TEMCO) to investigate the non-line...
The EGS Collab project is evaluating a site for Experiment 2 (hydraulic fracturing/shearing) at a depth of 1.25 km in the Sanford Underground Research Facility (SURF) on the 4100 Level. Two early test holes were drilled in an alcove (formerly known as Battery Charging Station) nea...
This package contains triggered 3-component surface nodal seismic waveforms recorded during the FOAL 1 experiment, or FORGE Observation Array Linear #1, which occurred during the April 2022 hydraulic stimulation of well 16A(78)-32 at the Utah FORGE EGS site. This data was utilized...
This experiment is testing the tube waves reflected from the bottom of the well. We put six single-channel geophones on the surface and a 24-channel downhole hydrophone into the well. The well is about 30 meters deep. Just a steel casing in the sand formation, no cement.
This submission is a follow-up to Distributed Temperature Sensing (DTS) measurements made in Brady observation well 56-1 during the PoroTomo field experiment conducted in March, 2016. The measurements in this data set were made on August 24, 2018 over an approximately 20 hour per...
In September 2013, an experiment using Distributed Acoustic Sensing (DAS) was conducted at Garner Valley, a test site of the University of California Santa Barbara (Lancelle et al., 2014). This submission includes one 45 kN shear shaker (called "large shaker" on the basemap) test ...
The EGS Collab is conducting experiments in hydraulic fracturing at a depth of 1.5 km in the Sanford Underground Research Facility (SURF) on the 4850 Level. A total of eight ~60m-long subhorizontal boreholes were drilled at that depth on the western rib of the West Access Drift. S...
Cymric oil field frequency domain electromagnetic (FEM) data with two parts of data labeled Part 1 and Part 2. Part 1 utilizes an electrical source line parallel to the receiver line, while Part 2 utilizes an electrical source line at a 75 deg angle to the receiver line. Data are ...
The data set shows performance of economical calcium phosphate cement (Fondu) blended with fly ash, class F (FAF) in carbon steel corrosion protection tests (corrosion rate, corrosion current and potential), bond and matrix strength, as well as matrix strength recovery after impos...
This is data from and a final report on the development of a 3D velocity model for the larger FORGE area and on the seismic resolution in the stimulated fracture volume at the bottom of well 16A-32. The velocity model was developed using RMS velocities of the seismic reflection su...
The submitted data correspond to the vibration caused by a 3.4 M earthquake and captured by the DAS horizontal and vertical arrays during the PoroTomo Experiment. Data is available in the original .sgy formats, as well as in standardized .h5 formats.
Earthquake information :
M ...
This submission includes an input file, plot file, Fortran conversion file, and 3D data file from the simulation of the temperature profile within the Test Bed #1 of the EGS Collab project. The simulation was executed with PNNL's STOMP-GT simulator, which reads the input file, and...
The submitted data correspond to the monitored vibrations caused by a vibroseis seismically exciting the ground in the vertical direction and captured by the DAS horizontal and vertical arrays during the PoroTomo Experiment. The data also include a file with the acceleration recor...
Input and output files used for fault characterization through numerical simulation using iTOUGH2. The synthetic data for the push period are generated by running a forward simulation (input parameters are provided in iTOUGH2 Brady GF6 Input Parameters.txt [InvExt6i.txt]). In gene...
The Newberry Volcano EGS Demonstration in central Oregon, a 5 year project begun in 2010, tests recent technological advances designed to reduce the cost of power generated by EGS in a hot, dry well (NWG 55-29) drilled in 2008. First, the stimulation pumps used were designed to ru...
Google Map