Search GDR Data

Kinetics of Chlorite Dissolution at Elevated Temperatures and CO2 Conditions

Chlorite dissolution kinetics were measured under far from equilibrium conditions using a mixed-flow reactor over temperatures of 100-275 degrees C at pH values of 3.0-5.7 in a background solution matrix of 0.05 m NaCl. Over this temperature range, magnesium was released congruent...

Carroll, S. et al Lawrence Livermore National Laboratory

Jul 01, 2013
1 Resources
0 Stars
Publicly accessible

Lithium Uptake Data of Lithium Imprinted Polymers

Batch tests of lithium imprinted polymers of variable composition to assess their ability to extract lithium from synthetic brines at T = 45 degC. Initial selectivity data are included

Ventura, S. SRI International

Dec 04, 2015
1 Resources
0 Stars
Publicly accessible

Laboratory Evaluation of EGS Shear Stimulation-Test 001

This is the results of an initial setup-shakedon test in order to develop the plumbing system for this test design. a cylinder of granite with offset holes was jacketed and subjected to confining pressure and low temperature (85C) and pore water pressure. Flow through the sample w...

Bauer, S. Sandia National Laboratories

Jul 29, 2014
1 Resources
0 Stars
Publicly accessible

Newberry EGS Demonstration: Initial Project Report and Induced Seismicity Mitigation Plan, 2011

This is the first project report and induced seismicity mitigation plan for the Newberry Enhanced Geothermal Systems (EGS) Demonstration project. The primary objectives of this first phase were to obtain necessary permits and comply with all regulations, including NEPA, communica...

Cladouhos, T. et al AltaRock Energy Inc

May 05, 2024
4 Resources
0 Stars
Publicly accessible

Deep Direct-Use Feasibility Study Numerical Modeling and Uncertainty Analysis using iTOUGH2 for West Virginia University

To reduce the geothermal exploration risk, a feasibility study is performed for a deep direct-use system proposed at the West Virginia University (WVU) Morgantown campus. This study applies numerical simulations to investigate reservoir impedance and thermal production. Because of...

Garapati, N. et al West Virginia University

Dec 20, 2019
13 Resources
0 Stars
Publicly accessible

Operational Performance Requirements For Motor Power Sections Used in Geothermal Drilling Based Upon Minimum Specific Energy

Operational performance requirements are needed to support development of specifications for downhole motor power sections to be used for drilling hard rock during geothermal wellbore construction. Theoretical torque specifications are derived based upon a widely-accepted rock-re...

Raymond, D. Sandia National Laboratories

Sep 10, 2014
1 Resources
1 Stars
Publicly accessible

Lithium and Manganese Uptake Data from Initial Set of Imprinted Polymers

Batch tests of cross-linked lithium and manganese imprinted polymers of variable composition to assess their ability to extract lithium and manganese from synthetic brines at T=45 deg C .

Ventura, S. SRI International

Mar 27, 2015
1 Resources
0 Stars
Publicly accessible

Stability of Elastomers Subjected to Geothermal Well-Like Conditions

The aim of this study is to understand how commercially available elastomers perform under geothermal well-like conditions and make recommendations to the community based on these results. This poster highlights the mechanical performance of several elastomers (including EPDM, Vit...

Redline, E. et al Sandia National Laboratories

Aug 10, 2014
1 Resources
0 Stars
Publicly accessible

Drilling Monitoring Program: Computer Program on Heat Transfer Temperature Distribution Hydraulic Calculations for Abrasive Jet Drilling

A program was created to evaluate the downhole conditions occurring in a FLASH ASJ drilling system. the program is meant to aid the operator of a coiled tubing rig in maintaining optimum drilling conditions.

Ozbayoglu, E. Impact Technologies LLC

Jan 01, 2011
1 Resources
0 Stars
Publicly accessible

Magnetic Test Loop Particle Retention Data for REE Extraction from Geothermal Fluids

Measurements of particle extraction efficiency under various flow rate and magnetic power conditions

McGrail, P. and Liu, J. Pacific Northwest National Laboratory

Jul 27, 2018
2 Resources
0 Stars
Publicly accessible

Life Cycle Water Consumption and Water Resource Assessment for Utility-Scale Geothermal Systems: An In-Depth Analysis of Historical and Forthcoming EGS Projects

This report is the third in a series of reports sponsored by the U.S. Department of Energy Geothermal Technologies Program in which a range of water-related issues surrounding geothermal power production are evaluated. The first report made an initial attempt at quantifying the li...

Schroeder, J. et al Argonne National Laboratory

Aug 31, 2013
11 Resources
1 Stars
Publicly accessible

Utah FORGE 5-2565: Evolution of Permeability and Strength Recovery of Shear Fractures Under Hydrothermal Conditions 2024 Annual Workshop Presentation

This is a presentation on the Evolution of Permeability and Strength Recovery of Shear Fractures Under Hydrothermal Conditions by United States Geological Survey, presented by Tamara Jeppson. This video slide presentation, by the USGS, discusses the determination of how thermal, ...

Jeppson, T. et al Energy and Geoscience Institute at the University of Utah

Sep 15, 2024
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Targeting Geothermal Resources with Geodetic Strain Data Paper

The paper linked below offers an initial assessment of a new method to target potential geothermal resources on the regional scale. The method is based on seeking relationships between geologic structures and geodetic observations of regional tectonic strain.

Blewitt, G. et al Energy and Geoscience Institute at the University of Utah

Oct 01, 2004
1 Resources
0 Stars
Publicly accessible

EGS Collab: Hydraulic Fracturing Test Measurements on the 4100L of SURF

This package includes data from two days of testing at the Sanford Underground Research Facility (SURF) on the 4100 level. The tests were performed in borehole TV4100 in the battery charging alcove south of the Yates shaft. TV4100 is a vertical borehole ~50 meters deep. A series o...

Ingraham, M. et al Sandia National Laboratories

Aug 15, 2019
3 Resources
0 Stars
Publicly accessible

Slip and Dilation Tendency Analysis of the Patua Geothermal Area

Critically stressed fault segments have a relatively high likelihood of acting as fluid flow conduits (Sibson, 1994). As such, the tendency of a fault segment to slip or to dilate provides an indication of which faults or fault segments within a geothermal system are critically st...

E., J. University of Nevada

Dec 31, 2013
1 Resources
0 Stars
Publicly accessible

Illite Dissolution Rates and Equation (100 to 280 deg C)

The objective of this suite of experiments was to develop a useful kinetic dissolution expression for illite applicable over an expanded range of solution pH and temperature conditions representative of subsurface conditions in natural and/or engineered geothermal reservoirs. Usi...

Carroll, S. Lawrence Livermore National Laboratory

Oct 17, 2014
1 Resources
0 Stars
Publicly accessible

Utah FORGE: LBNL Status Report on the VEMP Tool 2022

This report describes the current status of the Vertical Electromagnetic Profiling, or VEMP tool, that is on loan to Lawrence Berkeley National Lab (LBNL) from Geothermal Energy Research and Development Co., Ltd. (GERD), Japan. The report describes the initial inspection of the to...

Wilt, M. et al Lawrence Berkeley National Laboratory

Jun 24, 2022
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Core Material Friction Experiments

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct ...

Marone, C. et al Pennsylvania State University

Mar 15, 2023
7 Resources
0 Stars
Publicly accessible

Temperature and Pressure Data Brady Monitoring Well SP-2

Static Pressure and Temperature Log for Brady monitor well SP-2. This data was taken from Well SP-2 which is part of the Brady Hot Springs Geothermal Site. The data contains pressure and temperature vs depth data for RIH (run in hole) Static conditions and POOH (pull out of hole) ...

Akerley, J. University of Wisconsin

Jan 01, 2015
2 Resources
0 Stars
Publicly accessible

Development of a Neutron Diffraction Based Experimental Capability for Investigating Hydraulic Fractures for EGS-like Conditions

Understanding the relationship between stress state, strain state and fracture initiation and propagation is critical to the improvement of fracture simulation capability if it is to be used as a tool for guiding hydraulic fracturing operations. The development of fracture predict...

Polsky, Y. et al Oak Ridge National Laboratory

Feb 01, 2013
1 Resources
0 Stars
Publicly accessible

Utah FORGE: Laboratory Experiments Examining the Effect of Thermal and Mechanical Processes on Hydraulic Transmissivity Evolution

Using laboratory slide-hold-slide experiments, at temperatures from 22 to 200 degrees C, to examine effects of fracture reactivation and quasi-static loading on the evolution of fluid transport properties of simulated fractures in Westerly granite. At all temperatures, the in-plan...

Lockner, D. et al United States Geological Survey

Apr 03, 2023
2 Resources
0 Stars
Publicly accessible

Utah FORGE 5-2615: Well 58-32 and 78-32 Poroelastic Properties

Lab data on permeability, grain bulk modulus, drained bulk modulus, Skempton's pore pressure coefficient, and Biot's effective stress coefficient for Utah Forge Well 58-32 and Well 78-32. Work done as part of project number 5-2615 by the University of Oklahoma.

Ghassemi, A. and Zhou, X. University of Oklahoma

Oct 31, 2022
2 Resources
0 Stars
Publicly accessible

Shaker Table Experiments with Rare Earth Elements Sorption from Geothermal Brine

This dataset described shaker table experiments ran with sieved 50 +100 mesh media #1 in brine #1 that have 2ppm each of the 7 REE metals at different starting pH's of 3.5, 4.5, and 5.5. The experimental conditions are 2g media to 150mL of REE solution, at 70C.

Garland, G. Tusaar Corp.

Jul 21, 2015
4 Resources
0 Stars
Publicly accessible

Utah FORGE: Neubrex Well 16B(78)-32 Stimulation and Circulation Fiber Optics Reports Summer, 2024

This zip file contains reports discussing the use of fiber optics during well 16B(78)-32 stimulation and circulation tests in the summer of 2024. The reports cover the collection of strain rate and temperature change data during these well events. Theory, methods, and initial dat...

Jurick, D. et al Neubrex Energy Services (US), LLC

Sep 25, 2024
1 Resources
0 Stars
Publicly accessible

West Flank Coso FORGE: Seismic Reflection

PDFs of seismic reflection profiles 101,110, 111 local to the West Flank FORGE site. 45 line kilometers of seismic reflection data are processed data collected in 2001 through the use of vibroseis trucks. The initial analysis and interpretation of these data was performed by Unru...

Blankenship, D. Sandia National Laboratories

May 16, 2016
1 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 Next >>